Config / Version Advice for 8132f with 55xx, N20XX series
Dear All, I'm tasked to manage a set of 8132f as core switch (2 units stacked) with several 55xx, N20xx (edge switches stacked). Version on units as follow: 1) 8132f running 5.1.0.1, 2) 5548 running 4.1.0.12, 3) 2024 running 6.2.0.5, In the config, I found the following: Interface te1/0/1-2 channel-group 1 mode on Interface port-channel 1 switchport mode trunk switchport trunk native vlan 254 switchport trunk allowed vlan 3,7,9,12,254 Question: 1) Could someone advise me whether the version running are the recommended version to be running as of today. Asking coz I see some cli are not not working with current. Which version should it be running? 2) I noticed that when 'channel-group 1 mode on' is being used, it doesn't show partner info when 'show lacp port-channel 1' is run. Should it be changed to mode active instead? 3) Also, should I be seeing bandwidth > 10GB when int te1/0/1 & te2/0/1 are being used as port-channel? Appreciate your time and comments. Thank you.
Question: 1) Could someone advise me whether the version running are the recommended version to be running as of today. Asking coz I see some cli are not not working with current. Which version should it be running?
2) I noticed that when 'channel-group 1 mode on' is being used, it doesn't show partner info when 'show lacp port-channel 1' is run. Should it be changed to mode active instead? 3) Also, should I be seeing bandwidth > 10GB when int te1/0/1 & te2/0/1 are being used as port-channel?
Check the service tags on https://dell.com/support to look for the latest firmware versions. Active is LACP, mode on is a static port channel. If you have two 10G ports in a port channel it will depend on how you test for the bandwidth.
thearties
1 Rookie
•
8 Posts
698
0
Posted September 9th, 2019 18:00
Dear All,
I'm tasked to manage a set of 8132f as core switch (2 units stacked) with several 55xx, N20xx (edge switches stacked).
Version on units as follow:
1) 8132f running 5.1.0.1,
2) 5548 running 4.1.0.12,
3) 2024 running 6.2.0.5,
In the config, I found the following:
Interface te1/0/1-2
channel-group 1 mode on
Interface port-channel 1
switchport mode trunk
switchport trunk native vlan 254
switchport trunk allowed vlan 3,7,9,12,254
Question:
1) Could someone advise me whether the version running are the recommended version to be running as of today. Asking coz I see some cli are not not working with current. Which version should it be running?
2) I noticed that when 'channel-group 1 mode on' is being used, it doesn't show partner info when 'show lacp port-channel 1' is run. Should it be changed to mode active instead?
3) Also, should I be seeing bandwidth > 10GB when int te1/0/1 & te2/0/1 are being used as port-channel?
Appreciate your time and comments.
Thank you.