Hi, I had upgrade our netwoker server to a new machine with HP (Compaq) ESL9595 tape library. Everything went fine, except the barcode seem doesn't work anymore. And the barcode reader works fine on previous server.
what happen was, after upgraded to new server, I deleted old tape library and recreated the tape library by using jbconfig. jbconfig did find out that the ESL9595 has barcode reader, it asked me if I need to enable it, I said yes. after successful tape library installation. I was trying to inventory the tape library. however it didn't read from barcode, instead it load the tape and read label from tape. ESL9595 has 595 slots, it will take forever to inventory it.
I checked jukebox setting in the GUI, "Bar code Reader" and "match barcode label" are yes.
Hello, I think that barcode reader works fine (you can check it on library itself - does it shows inventory?). As I understand you created fresh autochanger on fresh/upgraded version of Networker. Because it has no inventory of volumes, Networker will check barcode as well as label on tape itself (they can be different...). So probably first time you will do inventory it will load tapes into drives and next time barcode reading will be enough. Maybe there is some way to avoid it but I'm not familiar with it...
In past you could avoid this by naming "new" library same as "old" one (so, location name field for tapes in media database would need to match newly created library name). I believe same should work here too.
Except those two settings already mentioned you wish to check if barcode feature has been autodetected during jbconfig (you will find that in advanced jukebox properties).
have you tried using sjirdtag to access the ESL9595, using the SCSI address of your jukebox run the the following and if it is showing you the barcodes in the Slots, ports and drives, then the reader is working fine.....
[root@bakprdinfl004 root]# sjirdtag 3.4.0 Tag Data for 3.4.0, Element Type DATA TRANSPORT: Elem[003]: tag_val=1 pres_val=1 med_pres=1 med_side=0 VolumeTag=<011624 > Elem[004]: tag_val=0 pres_val=1 med_pres=0 med_side=0 Elem[005]: tag_val=0 pres_val=1 med_pres=0 med_side=0 Elem[006]: tag_val=1 pres_val=1 med_pres=1 med_side=0 VolumeTag=<011626 > Elem[007]: tag_val=1 pres_val=1 med_pres=1 med_side=0 VolumeTag=<010357 > Tag Data for 3.4.0, Element Type STORAGE: Elem[001]: tag_val=1 pres_val=1 med_pres=1 med_side=0 VolumeTag=<010469 > Elem[002]: tag_val=1 pres_val=1 med_pres=1 med_side=0 VolumeTag=<010801 > Elem[003]: tag_val=1 pres_val=1 med_pres=1 med_side=0 VolumeTag=<010409 >
This i2k is is showing the barcodes of the media, so reader is working. If you want to check this properly, put a few tapes in your ESL Ports, run sjirdtag and if it shows the barcodes, it has reads them......hasnt used the drives to read internals...
pgolob
37 Posts
415
0
Posted May 5th, 2006 05:00