Degrader

updated

5 years ago

D

Degrader

8 Posts

0

1995

November 12th, 2021 14:00

U2720Q, HDR peak brightness lower with new firmware versions

Hi,

It looks like the peak HDR brightness is lower with the new firmware. My U2720Q with build date April 2021 has firmware version M2T104 and when playing HDR content with either DisplayHDR, Gaming HDR, Desktop HDR or Cinema HDR the peak brightness is about 350 nits. However if you use the non-HDR preset Gaming (so it is not in HDR mode), then the peak brightness is about 450 nits. A lot higher than in HDR mode. In the review of Rtings which reviewed an U2720Q before May 2020 and so had an older firmware version, the HDR peak brightness is around the 450 nits: Dell UltraSharp U2720Q Review - RTINGS.com

Please can you release a firmware update where the HDR peak brightness wil be restored to the 450 nits? The monitor is capable of it as the non-HDR gaming mode gives 450 nits.

  • Degrader

    8 Posts

    1222

    0

    Posted November 17th, 2021 06:00

    I've bought a SpyderX last week and did some HDR peak brightness measurements and I can confirm that the 450 nits is achieved (467 nits at highest). Tweakers published today their measurements of the second unit and the results are now as expected. To be honest, these results are extremely good for a HDR400 monitor! Well done, Dell! So conclusion is that something went wrong with their first measurements and that I have learned that firmware version has no impact on the HDR peak brightness of the U2720Q.

     

    Kind regards,

    Samir

  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    1283

    0

    Posted November 13th, 2021 09:00

    Note the wording on page 41 in the online U2720Q User's Guide =

    Capture.JPG

    The only firmware that Dell released to the U2720Q driver page was the Apple macOS firmware M2T105. That was only released to allow the usage of the new DDM for macOS.


    DELL-Chris M (old account)

    #IWork4Dell

  • Degrader

    8 Posts

    1240

    0

    Posted November 17th, 2021 00:00

    I know that Dell only released M2T105, but the monitors are shipped with different firmware versions. And I also know that peak brightness can vary depending on HDR content. But when measuring the highest peak brightness in the official Vesa DisplayHDR test my unit reaches 350 nits (i've tried all the four HDR modes). So my maximum peak brightness is 350 nits. While my unit is capable of 450 nits as I see this value when I set the monitor to Game mode (this is not a HDR mode).

    Hardware.info measured with their unit (which was also shipped with newer firmware than M2T101) also a maximum peak brightness around the 350 nits in during the test. See: Dell UltraSharp U2720Q monitor - Hardware Info

    Rtings measured with their unit which was shipped with M2T101 a maximum peak brightness around the 450 nits in during the test. See: Dell UltraSharp U2720Q Review - RTINGS.com

    So there is certainly a difference in the maximum peak brightness between units, and it looks like that it is related to the firmware versions where the unit were shipped with. I hope that you understand my point.

    I've asked Rtings to update their unit with the newer firmware and do the measurements for the HDR peak brightness again and to update their results.