Problem connecting PS3 to 2407WFP through Component
Hi, I purchased a Sony component cable in order to hook my PS3 up to my 2407WFP monitor and I'm having problems. When I hooked it up, I reset the PS3 display settings by holding the power on button, then started the PS3 and nothing would show on the screen. I hooked up the component cables to a TV and it was working fine. The revision of the monitor is A03. I don't want to get a HDMI-DVI cable because I don't like switching cables as I also use it as my main display for my PC. Also, picture-in-picture is another important reason why I want component.
* Power off the monitor
* Disconnect all cabling from the bottom and/or sides of the monitor (especially the power cord). Disconnecting the power cord releases all circuit latches "resetting" them
* Press and hold the monitor power button down for 5 seconds
* Reconnect only the monitor power cord and either the #1 blue VGA or #2 white DVI (not both)
* Power on the monitor
* The PC should already be on. The monitor should auto sense the #1 blue VGA or #2 white DVI. If it does not, press the Input Select button and change to #1 VGA or #2 DVI
* Reconnect your device to the monitor components
* Power on that device
* Press the Input button and switch to the component setting
On another topic though, when I go to set my resolution as 1080i, it works, but the screen flickers like an old CRT and the quality is worse than 720p. When I switch it back to 720p, the flickering goes away and I get a nice solid, high quality picture. I thought 1080i was supported through component, what gives?
Looking back at all of the documentation that came with the monitor, I was able to determine that it's a 2407WFP, not 2407WFP-HC. 480i, 480p, and 720p all don't flicker by the way - just 1080i. Thanks for your input though.
DELL-Chris M
Community Manager
•
56891 Posts
•
232143 Points
215
0
Posted August 8th, 2007 13:00
So, the PS3 + Sony component cable + TV work.
* Power off the monitor
* Disconnect all cabling from the bottom and/or sides of the monitor (especially the power cord). Disconnecting the power cord releases all circuit latches "resetting" them
* Press and hold the monitor power button down for 5 seconds
* Reconnect only the monitor power cord and either the #1 blue VGA or #2 white DVI (not both)
* Power on the monitor
* The PC should already be on. The monitor should auto sense the #1 blue VGA or #2 white DVI. If it does not, press the Input Select button and change to #1 VGA or #2 DVI
* Reconnect your device to the monitor components
* Power on that device
* Press the Input button and switch to the component setting
DELL-Chris M (old account)
#IWork4Dell