UNSOLVED

jslapp

updated

11 years ago

J

jslapp

16 Posts

0

211117

November 26th, 2015 05:00

Samsung NVMe 512 GB hard drive on XPS 15 diagnostics fail with Could Not Send DST Short

After an entire week of troubleshooting out of the box, 18 phone calls, a full system board replacement, and two hard drive replacements, I am Still receiving errors on the hard drive during diags. Cannot believe this is a hardware fault after all this. I have three drives all reporting the same issue. What are the odds? "Could not send DST Short": incorrect status 8000000000000003 Error code: 2000-0151 I still do have instability but I believe it is mostly now related to Windows 10. No where near the instability I had all week with the faulty motherboard. Is anyone else seeing similar issues?
  • 2318

    0

    Posted January 6th, 2016 09:00

    I am also having this issue.  Have you made any progress in resolving this?

  • jslapp

    16 Posts

    2318

    0

    Posted January 6th, 2016 17:00

    No. I returned it and bought from another vendor. I could have bought ten of them with the man hours I wasted on trying to fix all the problems. Support is an epic fail. I'm not bitter though. Good luck.

  • Chugo

    8 Posts

    2318

    0

    Posted January 6th, 2016 21:00

    I've had this same exact problem and have had my drive also replaced and it the error still pops up. I've already contacted dell customer support and they're pretty useless... my computer is running fine at the moment so going to cross my fingers that its nothing major...

  • Gadfu

    8 Posts

    2318

    0

    Posted January 7th, 2016 13:00

    Dell Tech support told me, their diagnostics software isn't suited for NVMe drives yet and always shows an error for those. 

    Shows me the same error with absolutely no stability issues. 

  • 2318

    1

    Posted January 8th, 2016 05:00

    Yeah our diagnostics don't have support for NVMe yet. There'll be BIOS updates coming out that will update the diagnostics for NVMe support.

    **UPDATED**

    There's a workaround to get the diagnostics to test the drive successfully- 

    1.Note the SATA Mode

    2.Change the SATA mode to AHCI in the BIOS, then run the diagnostics 

    3.Once the diagnostics have completed go back into the BIOS and change the SATA mode back to the setting it was on so the system will boot to the O/S