UNSOLVED

rfitzva

updated

21 years ago

Closed

R

rfitzva

13 Posts

0

6380

September 27th, 2005 00:00

Inspiron 6000 defective out of the box.

I made a big mistake and did not return the machine within the 21 days. The machine has blue screen crashes. It first happened several hours after I started the machine. It had only XP and Norton maintenance applied. None of my software, no new drivers. After the machine passed it's diagnostics, I ran the PC restore. I allowed no XP or Norton updates. It still had blue screen crashes. I have since tried a third time. This time it barely completed the restore. I got as far as entering a name for the computer and it crashed. This is either an intermittent hardware problem, or the machine was shipped with a defective driver.

The Microsoft crash report blames an unknown driver. The Dell crash analysis program is not helpful.

My experience so far with tech support and customer service has not been good.

If it is a software problem, I may be able to install from scratch and get it working, but this is clearly a Dell problem 21 day limit or not and it would be nice if somebody would take responsibility for resolving it.

So far when I asked for a supervisor, one person lied to me, one customer service supervisor (if he really was one) lied to me about transferring me to a tech supervisor. Earlier a customer service person lied about transferring me to a technician.

One technician I chatted with eventually suggested I wipe the disk, but did not point me to a document that actually explained how, and then he assigned a case number just before closing the session so I could not write it down.

A subsequent email to tech got me a technician who failed to look up the chat and then suggested I do a PC restore. Which my message said I had already done.

I have also been told that since it is a software problem, I should use their pay software support.
  • asd34567

    112 Posts

    888

    0

    Posted September 27th, 2005 07:00

    Before you do anything else, do this:

    1) Shut down and disconnect everything from the 6000 except the ac adaptor.

    2) Start up and immediately press and hold down both the Control and F11 key. Do not release these two keys until after your 6000 continues to beep and you see the Symantec Dell PC Restore screen. You can let go of the keys when you're presented with the choice to proceed with the restore.

    3) If the computer boots up to the desktop instead of going to the Symantec Dell PC Restore screen, shut down again and repeat from step 1. Sometimes you'll have to repeat this sequence two or three times before it will work. You may even have to tap these two keys together twice during that very short startup period where you see the blue Dell logo startup screen to get the Symantec Dell PC Restore screen to appear.  Keep trying.
     
    4) Once you get to the Symantec Dell PC Restore screen, go ahead and complete the restore. Eventually, it will complete and you will get back to the desktop with a fresh, clean restored hard drive. If you cannot get this feature to work because you changed your hard drive partitions or software or because the hard drive got corrupted, you'll have to beg Dell to replace your hard drive with one that has your original software image pre-installed so this feature works. You'll probably have to insist on talking to a supervisor to get the warranty replacement with your original software image.
     
    5) When you get to this uncorrupted state, restart your 6000 and run Dell diagnostics by booting into the diagnostics partition by holding down F12 at startup. First, you'll see the blue Dell diagnostics screen. It should pass all pre-boot tests. Afetr the blue screen pre-boot tests (which should all pass) you should see the Press Any Key to Boot to Diagnostics Partition gray screen. Insert any factory CD in the drive and run the diagnostics quick test and see what the results are. Everything should pass.
     
    6) If everything passes, remove the CD you used to test the CD drive and close the diagnostics box and the 6000 will boot up to the desktop. If not, record the error messages exactly and post back here for further help.
     
    At this point, hopefully you'll know that the 6000 passed all Dell diagnostics and has a clean software image restored to the hard drive. Try running the 6000 for awhile and restarting a couple of times. If you get any system crashes, record exactly what the error messages say and post back here for further help.
     
    If you don't get any crashes, go ahead and reconnect your devices one at a time and restart your 6000 and repeat this add-a-device-and-restart-and-run for awhile until it starts to crash. That's usually the point where you can blame a connected device for the instability. Post back here with a complete description of your crash for further help.
     
    If you still don't get any crashes, start to make the software changes you want to and do the restart and run thing and see if the 6000 starts to crash. Same process for software crashes as hardware crashes - post the exact error message back here for further help.
     
    Now, realize this: If you can't get the Symantec Dell PC Restore  to work either by following the steps above or by having Dell replace your drive, you'll have to completely reinstall your system software and that's not a pretty prospect for anyone other than those with considerable OS installation experience. That's for a whole new thread.
     
    Your experience with Dell tech support so far is typical when the type of crashing you described occurs. You'll just have to persist in getting the above steps to work. Otherwise, you'll have to become an OS software installer overnight.
     
    Good luck and be sure to post back here with what steps you followed, what the results were and what, if any, the error messages are.
  • rfitzva

    13 Posts

    888

    0

    Posted September 27th, 2005 10:00

    I had no devices attached. With the exception of testing with a CD in the drive, I have done the full restore 3 times. The CD drive works because I used it to install Partition Magic. I wanted to backup the drive before starting from scratch. However, Partition Magic will not copy the DOS boot partition, and gets an undocumented 702 error trying to copy the restore partition. I also have Ghost but haven't tried it yet. Partition Magic does have a browse function which will show the files in the restore partition and appears able to save individual files.

    If I leave the machine booted up over night, it will usualy have a blue screen in the morning. I left it overnight booted in save mode and on the login screen. It did not crash. Interesting, but doesn't really get me anywhere.

    I paid for the restore disk when I ordered the machine and am experienced at installing Windows. I will probably go ahead and do it, but would prefer to have a backup of the original disk so I am not burning my bridges.
  • asd34567

    112 Posts

    888

    0

    Posted September 27th, 2005 12:00

    Sorry, I guess I misread your first post. I thought you had done an XP system restore vs. a Dell pc restore.
     
    Well, if your machine passes all tests as I described above (pre-boot and diagnostics partition) and you still have those kinds of problems after a successful Dell pc restore, I would bet you either have a bad hard drive (which includes a bad restore image) or you have bad memory DIMM's or motherboard components which heat up over time and fail or go out of spec.
     
    You could try a few re-seating actions like removing the battery and re-seating memory Dimm's, optical and hard drives although I doubt that would have any effect on your problems.
     
    Run diagnostics (if you can) when the machine is fully warmed up and see what results you get. Run an extended memory test. And, call Dell and request a new hard drive with your original software image - that's the most likely suspect.
     
    Please let us know what you find.
     
     
  • rfitzva

    13 Posts

    888

    0

    Posted September 27th, 2005 13:00

    It crashed again today and this time (like only one previous) it reported a page fault in non paged area. A very odd error.

    I did make a ghost backup. I deleted the partition and am doing a full format. Hopefully the install will run. I ran into problems first try. It would not let me clear the partition because it's own files were there. Then when I let it continue it failed to copy file after file. It did get far enough to make the partition unbootable.

    I used Partition Magic to delete and recreate the partition and XP install is now doing the full format.

    I would like to leave the diagnostics running overnight, but I don't believe I saw any option for continuous testing.

    By the way, the machine has 2GB ram which means high density memory.

    I assume this, like most memory, has no parity checking so memory errors are only detectable by a diagnostic program. It made sense when 640K cost $600. Now it's ridiculous.

    I see it has started copy files now. I will post another message when something happens or if I get through a couple days without a crash.

    thanks
  • asd34567

    112 Posts

    888

    0

    Posted September 27th, 2005 23:00

    Go to Dell Downloads and get the Intel WLAN card driver that just got released. It addresses your network problems.
  • rfitzva

    13 Posts

    888

    0

    Posted September 27th, 2005 23:00

    I have installed XP from the restore disk. Installed the all the drivers from the the drivers disk. Installed the Norton and Wordperfect disks. Run windows update and Norton LIveupdate. I installed Ghost and made a new backup.

    No sign yet of a blue screen. However, now my wireless access is highly erratic. Up to now it has shown an amazing number of networks. Things like AlexandriaWireless which is supposed to be more than a mile away.

    Now only my own and one or two others seem to me showing, and although my router shows with five bars it keeps dropping it. It never recovers it. I have to boot to get a connection again. I also get a screen which shows it disconnected and offers to disconnect it. I can fool around and get it to say connect again, but it never works.
    Also my router comes and goes from the available list.

    All this while another laptop sitting right next to it has no problems with the connection.

    re-installing the drivers did not help. If there are newer drivers I have not found them. I came across a link saying it was to new drivers just out of beta, but the file at intel did not appear to be for 2200BG.

    By coincidence, I had a blue screen crash on my Desktop this morning. Microsoft crash analysis came back and asked me to set my machine for a kernel dump and wait to see if it happened again.

    I went ahead and did that on the 6000 as well. I will change the settings to keep it awake and leave it over night to see if I get the blue screen again.
  • wmattox

    8 Posts

    888

    0

    Posted September 28th, 2005 06:00

    Very interesting posts.  I have exactly the same problem with my Inspiron 6000 with the same results.  Dell idiots kept recommending a Dell Restore so I could return the computer to the same crash prone condition it arrived in.  I finally gave in and did the restore but did not solve a thing.  Finally, I purchased WinXP (Dell did not send it with the computer and have refused to send me a copy) and did a clean install.  Now I my frequent blue screens of death are supposedly caused by a driver issue (according to Microsoft) and I am no longer getting the page faults.  My guess is that Dell has a bad driver for the Inspiron and they are in a state of denial.  Dell has refused by request to return the computer and yet can not offer a fix.  I can attest to the fact that a Dell restore, a clean install of WinXP, a bios update, using the latest drivers on Dell's website and contacting Dell will not fix the problem.  Hopefully someone will find a solution.  Good Luck, Wayne

  • rfitzva

    13 Posts

    888

    0

    Posted September 28th, 2005 11:00

    That was pretty vague.

    I have installed 9.0.2.31 07/19/2005

    It still drops the connection after a few minutes and requires a boot to connect again. Before it drops, it works, I can browse and download.

    Is there something newer?

    By the way, the diagnostics have nothing for the wireless.

    The computer survived the night without a blue screen. What's strange and frustrating is that the Wireless was working fine between the blue screen crashes.
  • rfitzva

    13 Posts

    900

    0

    Posted September 28th, 2005 18:00

    Too soon to be sure, but I think I have a working Dell 6000 now. No blue screen crash for over a day. I think I have fixed the WiFi problem. In addition to the new drivers from Dell Downloads, I had to remove and add back the SSID entry for my router. When I added it back it had WEP turned on, I turned it back off. When I did it reconnected without a reboot and is still connected 2 hours later.

    Of course this proves that subject line is true. At a very conservative estismate Dell owes me for at least 20 hours of time fixing their problem. At an equally conservative hourly rate of $50, Dell owes me $1000.

    If there are two of us, I wonder how many more there might be.
  • jovz

    25 Posts

    532

    0

    Posted September 28th, 2005 23:00

    I would like to suggest to  let tech support know about your issue.

     

    or  try to ask for a harddrive with softwares already since your system is new.

     

     

     it might work