UNSOLVED

Phy

updated

18 years ago

P

Phy

4 Posts

0

15307

October 15th, 2008 16:00

XPS 730 "looses" monitor on reboot

I just received my XPS 730 running WinXP Pro with dual NVIDIA GEFORCE 9800GT,SLI. I, also, purchased a Dell SP2009W 20 inch Widescreen Flat Panel Monitor to use with the system.

 

I got it all setup up and turned on for the first time and got no display. I connected my old monitor from my previous PC and was able to get a monitor connection, finish setup and boot into Windows.

 

I disconnected the old monitor and connected the Dell monitor and it worked, was able to set the screen resolution to 1680 X 1050 and it was beautiful.

 

I ran Windows updates and rebooted and on reboot I get "entering power saving mode" and nothing on the monitor again. I disconnected the Dell monitor and reconnected the old monitor and got display. Once in Windows I switched back to the Dell monitor and it worked normally after resetting the resolution again.

 

Every time I reboot this PC after running updates or installing software I lose my monitor connection and have to connect the old monitor in order to get into Windows to change the display settings, then disconnect that monitor and reconnect the new one.

 

When I got up this morning I went to check on it and it had gone into power save mode during the night and I had to switch the monitors again in order to get a display.

 

Does anyone have any suggestions?

 

 

  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    612

    0

    Posted October 15th, 2008 17:00

    Phy,

    Are you saying on a restart but not coming out of sleep mode it does this?


    DELL-Chris M (old account)

    #IWork4Dell

  • Phy

    4 Posts

    612

    0

    Posted October 15th, 2008 18:00

    Hey Chris,

     

    It appears to do it both on a reboot and coming out of sleep mode.

     

    Last night it was with reboots. This morning it was sleep mode. I didn't try rebooting this morning because I had to leave for work.

    Message Edited by Phy on 10-15-2008 12:39 PM
  • Phy

    4 Posts

    611

    0

    Posted October 15th, 2008 19:00

    Let me add something I should have put in my original post.

     

    When I reboot the PC with the new monitor attached I see the Dell Boot screen and then the www.dell.com screen and then the Windows XP loading/splash screen.

     

    During the Windows loading screen is when I get the "entering power save mode" notice and then the monitor goes black. I switch the monitors from the new to the old and the system is sitting at the Windows logon screen.

  • matt92109

    24 Posts

    611

    0

    Posted October 15th, 2008 20:00

    Now that you mention this I recall having the exact same problem with my 730 when I first received it, and ended up doing the same thing as you - monitor swapping - to get a visible screen. (Dual 9800 GTs also)

    I forgot about it because I installed vista 64 bit pretty quickly after receiving my system and havent had that same problem since.

    Try doing a complete re-install with your OS of choice... I really didnt like the image that came with my system - it had that problem and also wouldnt boot up properly half the time...and its probably the same image as is on yours as I have only had mine for 2 weeks today... 

    That said... since doing a clean install, I have not had a single problem.. 

    Good luck!

    Message Edited by matt92109 on 10-15-2008 02:33 PM
  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    611

    0

    Posted October 16th, 2008 03:00

    Phy,

    Try this. The PC and the monitor are both on. Power the PC off. Turn the monitor off. Power the PC on (I know the monitor is still off). Wait 30 seconds and power the monitor on. Does the PC now see the monitor and boot into windows?


    DELL-Chris M (old account)

    #IWork4Dell

  • Cor-Mega

    16 Posts

    611

    0

    Posted October 16th, 2008 12:00

    Hello Sir,

     

     

    I actually experienced this problem about a week ago when i tried to install new nvidia drivers, It seems to happen right when you are rebooting the system and sometimes when you leave it idle. I noticed that the OS would recognize it as a pnp monitor and not let your current monitor install. 

     

    I fixed the issue by completely removing the new nvidia driver that came with a physx driver, i came to the conclusion that the physx driver was the culprit but i havent tried to reinstall the new updated driver yet since i made it work and left it as it is... IM LAZYYY HEHEH. 

     

     

     

  • Phy

    4 Posts

    611

    0

    Posted October 16th, 2008 14:00

    Chris,

     

    Thanks for the troubleshooting steps but I has already taken Matt's suggestion before I saw this.

     

    I did a clean install of Vista Ultimate last night and am now able to reboot and come out of sleep mode without having to switch monitors around. Everything seems to be working normally now.

     

    I can't wait for WoW to finish installing, I'm so excited!!

     

    Thanks!

  • matt92109

    24 Posts

    611

    0

    Posted October 16th, 2008 15:00

    Fantastic news! Congrats on your new system and have fun!
  • matt92109

    24 Posts

    175

    0

    Posted October 16th, 2008 17:00

    Chris - do you happen to know which driver came installed on the image we would have received - FYI my system came with an XP-Pro image.

     

    I can confirm that the latest nvidia drivers 178.24 (released yesterday) work fine, as did the previous one - 178.13.

  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    611

    0

    Posted October 16th, 2008 17:00

    Phy,

    Make note of the video card driver version your now using that works. I would not let Windows Update load another video card driver.


    DELL-Chris M (old account)

    #IWork4Dell