UNSOLVED

jettmorrison

updated

19 years ago

0

5582

September 1st, 2007 16:00

Updating BIOS Dimension 8100 for dummies

I'm a newbie when it comes to computer maintenance and I'm attempting a major overhaul of my 8100; i.e. update bios, update RAM, locating necessary device drivers for reformatting c:/ drive, etc.
 
I haven't updated my bios since I first bought the computer so I"m still using A02 but I see that version A09 is out. Question: one, can I even use this version on my computer? If so, the versions look to only be bootable from a boot disk and I read somewhere that we are past that point. So how do I download and update to BIOS A09 without using a bootdisk. If I have to use a boot disk, (the directions have been followed perfectly), it doesn't boot right after I restart on the a: drive and gives me an error message upon the reboot.
 
This is the best that I can explain my issues. Any help is appreciated.
 
Dimension 8100
Windows xp
Bios A02
  • jackshack

    6447 Posts

    136

    0

    Posted September 1st, 2007 23:00

    Yes, you can use A09 but Dell recommends that you use XP2 (BD81XPP2.exe to get the version that makes a bootable floppy disk) if you are using the Windows XP os.  You can get this by going to the downloads, clicking on bios updates, and clicking on the Other Versions link below the download box for A09.  Once you have downloaded the file to its own folder on your hard drive, put a blank 3.5 inch floppy into your A: drive and double click on the file.  It will self extract and load the code needed to make a bootable floppy in your A: drive.  When done, restart the machine, tap F12 for the boot menu, and select the floppy drive as the boot device.  The computer should boot to DOS and run the update code automatically.  It requires about thirty seconds.  When it is done it will prompt you to remove the floppy disk and hit any key to reboot.
     
    A word of caution; be sure you really want to do this.  If you need to load the bios update to correct a problem you are having, ok.  If you are doing this simply to have a later version of the bios remember that bios updates do present a risk of failure.  If the update fails the only way you repair the computer is to replace the motherboard.  Dell does not have a "repair" option for failure of the bios flash.  Do not perform the procedure if there is a probability of losing power, such as during a thunderstorm.  If the power fails during the flash there is no way to recover.
     
    Good luck!