UNSOLVED

Communiverse

updated

14 years ago

0

61171

February 19th, 2013 07:00

Targeted Read and Smart Short Self Tests Failed

Hi,

My new XPS 2710 desktop has just produced failed messages for targeted read test WHD20-71V and smart short self test WHD16-RCF.  I switched it on for the first time on 31st December, and it's already had a new motherboard.  I hope it doesn't need more new parts.  It's less than 2 months old!  Thanks for your advice.

Regards,

Pauline.

  • speedstep

    11 Legend

    •

    46969 Posts

    683

    0

    Posted February 19th, 2013 09:00

    Hi,

    My new XPS 2710 desktop has just produced failed messages for targeted read test WHD20-71V and smart short self test WHD16-RCF.  I switched it on for the first time on 31st December, and it's already had a new motherboard.  I hope it doesn't need more new parts.  It's less than 2 months old!  Thanks for your advice.

    Regards,

    Pauline.

    I don't know that there is a PCDOCTOR code list anywhere.

    The errors indicate a failed hard drive.

    PC-Doctor failure codes

    PC-Doctor displays an error code, problem description, and helpful tips at the completion of the test.
    For example:
    Error code: MC921-W No Dialtone. Make sure you have a working phone line.
    Use the problem description and suggested fixes to help in resolving the problem.
    PCs have SMART (Self-Monitoring Analysis and Reporting Technology System) capable hard drives. SMART is firmware that resides on the hard drive and continuously monitors drive parameters such as performance and error rates. SMART uses a technology known as predictive failure analysis to tell you when a hard drive failure is imminent.
    Common SMART errors are:
    • Hard disk failure is imminent.
    • A hard drive in the system reports that it may fail.
    • Smart failure imminent, back up your data
    • Error 1720 Imminent Hard Drive Failure
    • Hardware Diagnostic errors that start with WHDXXX
    The use of SMART does not prevent all hard drive failures, but it can give you the opportunity to back up your personal files and replace the hard drive before it fails.
    Saving files before replacing a hard drive
    Before replacing the hard drive, create a set of recovery disks, and then back up your personal files to an external storage device, such as a USB drive, recordable discs, floppy disks, or another hard drive. After installing a new hard drive and performing a system recovery, the new hard drive will only have the operating system loaded. Personal files can be restored to the new hard drive after completing a system recovery.
    What does PC-Doctor error code "nnn" mean?
    Answer: The error codes that appear after a PC-Doctor test are designed to quickly allow PC manufacturer's technical support team to determine which tests failed. You should contact technical support to find the meaning of an error code. We maintain a list of links to manufacturers' websites on our home page at http://www.pc-doctor.com/

    General data recovery methods:

    *IMPORTANT* - If there is any question that the drive is at fault - it's
    making noises for instance - and the data is crucial DO NOTHING FURTHER
    ON THE DRIVE. Every time you spin that drive up you may be destroying
    data. If this is the case, send the drive to a professional data
    recovery company like Drive Savers (my preference) or Seagate Data
    Recovery. General prices run from $500USD on up. Drive Savers recovered
    all the data on a failed laptop drive for one of my clients and it cost
    $2,700. He thought it was worth the money; only you know what your data
    is worth. I understand that some insurance companies are now covering
    data recovery charges so check with yours.

    Drive Savers - http://www.drivesavers.com
    Seagate Data Recovery Services - https://www.seagatedatarecovery.com/

     

    Also, note that when the error is INDETERMINATE, we need to restart the system and try the test again as this doesn’t mean a failure of the hardware part.

     

    PC-Doctor Test Results and Error Codes

    Test Result

    Exit Code

    Description

    PASS

    0

    Test Passed.

    UNKNOWN ERROR

    19

    Internal PC-Doctor Error. Contact support.

    TEST NOT STARTED

    20

    Internal PC-Doctor Code. If a test ends with this result and the script was not aborted by the user or by a halt-on condition, contact support.

    TESTING IN PROGRESS

    21

    Internal PC-Doctor Code. If a test ends with this result, contact support.

    INTERNAL ERROR

    22

    Internal PC-Doctor Error. Contact Support

    FAIL

    23

    A hardware defect was detected. If you believe the hardware to be good, contact support.

    USER ABORTED

    24

    Testing was aborted by the user.

    DEVICE BUSY

    25

    Testing could not begin because the device is locked by the hardware or operating system.

    INSUFFICIENT PRIVILEGE

    26

    Testing could not begin because the user does not have sufficient privileges. Try running as an administrator.

    NOT SUPPORTED

    27

    Device does not support a functionality that this test required to run. Usually a driver issue.

    CANNOT RUN

    28

    Device supports this test but cannot run for unknown reasons. Usually a driver issue.

    BAD PARAMS

    29

    Bad parameters were passed to the module from the client or settings file.

    NO MEDIA

    30

    Required media to run test was not found in the device.

    NO DEVICE

    31

    This device was not detected on the system. It may have been removed (which can happen with hot-swappable devices).

    NO TEST

    32

    This test is no longer detected on the system. Contact support.

    NO MODULE

    33

    This module is no longer detected on the system. Contact support.

    EXEC FAILED

    34

    The execution of the module failed. Contact support.

    MODULE FAILED TO START

    35

    Internal PC-Doctor error. Contact support.

    DUPLICATE GUID

    36

    Internal PC-Doctor error. Contact support.

    MAX TIME EXCEEDED

    37

    The test was cancelled because the maximum amount of time for testing was exceeded.

    EXITED ABNORMALLY

    38

    Internal PC-Doctor error. Contact support.

    INCORRECT MEDIA

    39

    Media present in the device was incorrect.

    NO CABLE

    40

    No network cable was detected.

    NO CONNECTION

    41

    Network adapter is not connected.

    NO INDICATOR

    42

    Internal PC-Doctor error. Contact support.

    DEVICE NOT TESTABLE

    43

    The device is not testable because of an incorrect driver or other configuration problem.

    DEVICE DISABLED

    44

    The device is disabled by the user or operating system.

    MISCONFIGURED

    45

    The configuration of this device does not allow testing.

    DEVICE TESTING BLOCKED

    46

    Another hardware test is currently using this device.

    NODIALTONE

    47

    The dialtone test cannot detect a dialtone from the modem.

    NOTAPPLICABLE

    48

    The test is not applicable for the hardware.

    NO SIGNAL

    49

    No signal was detected.

    LOW SIGNAL STRENGTH

    50

    The signal strength is too low.

    WARNING

    51

    The test produced important warnings.

    INDETERMINATE

    52

    The test could not determine a FAIL or PASS result. Close all applications or reboot computer and try again.

    SKIPPED

    53

    The test was skipped.

    COMPLETED

    55

    Used for tests where returning PASS or FAIL is not appropriate (such as Bluetooth test).

    TESTINGHALTED

    56

    Script halted due to HALTON being set.

    DEVICE ABORTED

    57

    Testing was aborted by the device.

    TIMED OUT

    58

    Testing was stopped because the test was taking too long.