
UNSOLVED
T7400 SAS 6 IM creation with existing disk.
My T7400 has 4 disks 2 SAS and 2 SATA. The 2 SATA disks are IM raid 1, the first SAS disk is the boot disk and system disk. The second SAS is not used.
Now I want to start mirroring the 2 SAS disks, using the existing data on the system disk.
When in the configuration utility I can select the first disk, but it immidiately warns me that the disk contains data and it will be lost. And that is not what I want.
I was looking for a manual but could only find something at LSI , the manual looks exactly the same to what I see in the configuration utility:
Move the cursor to the RAID Disk column and select a disk. To add
the disk to the volume, change the No to Yes by pressing the + key,
− key, or space bar.When the first disk is added, the SAS BIOS CU prompts you to either
keep existing data or overwrite existing data.
But this last part is not what happens in my system, do I require an update of the firmware to get this?
I saw there has been released a new driver and firmware recently.
A side question, is there any software that allows the creation/ managment / monitoring of the RAID disks from within windows vista (like there is for the Intel Matrix Storage).
Thanks
Geeds
Responses (5)
Solutions (0)
So I went another way:
I added a SAMSUNG SATA disk to the SATA 1 connector (next to the SATA 0 of the CDWRITER).
I used PCDISKCLONE to clone the system disk.
I then went to the F12 bootmenu and told it to boot from the SAMSUNG disk, just to see if I have an exact copy.
The system booted fine, but when I look in diskmanagement, disk 0 is the samsung disk and disk 1 the SAS (original system disk). But the C partition is assigned still to the SAS disk. That is not what I had expected, I assumed that booting from the SAMSUNG disk, the C partition would be on the SAMSUNG disk as well.
And if I take out the SAS disks and boot from the SAMSUNG disk, it cannot find the operating system during the boot.
So can the bootsector of the samsung disk still point to the OS on the SAS disk?
And most importantly, can I expect the system to work if take out the samsung disk after I have created a RAID 1 of the two SAS disks and use PCCLONEDISK to clone the SAMSUNG disk back to the new SAS RAID.
Thanks
Ben
A little bit more info:
I managed to create a dual boot profile
1) Vista using SAMSUNG
2) Vista using SAS
If I boot in 2 (SAS), in disk management I see that the SAS disk is partition C: and is 'boot disk, system disk'
and the SAMSUNG is just partition K:
If I boot in ! (SAMSUNG), in disk management I see that the SAS disk is partition C: and is 'system disk'
and the SAMSUNG is partition K: (boot disk)
So now I just need to make K: also the system disk...how to?
Tnx

BobL55
2 Intern
•
101 Posts
299
0
Posted October 3rd, 2008 15:00