
UNSOLVED
Scan Hard Drive
Does Dell have an online facility to scan the disk for errors.
I am getting error code7 bad disk block more and more often, with the pc freezing up.
Don't think it is a power supply problem or a sudden loose cable, and if it were the motherboard won't there be other symptoms.
I have run chkdsk and fix errors a few times and defraged, but no luck..
Responses (7)
Solutions (0)
shesagordie
12 Elder
•
46017 Posts
1066
0
Posted August 4th, 2008 19:00
hary uk
To add to Davet50's excellent post.
Replace the hard drive ASAP, Error Code 7 means the drive failed its self-test. Therefore the hard drive, is indeed failing. Backup any data, that you wish to save, to other media.
If your system is under warranty, contact Dell for replacement and give the Techie the error message.
Bev.
===================================================
Please don't send me questions about your system by DCF Messenger.
Post the issue in the appropriate Board, where they will be answered.it will but 99% will not work. Programs install a lot of hooks into the registry and scatter parts of their files to other directories. You best bet is to get an image or start digging out any disks.
You can use the files and settings transfer wizard to save your settings and limited files this would not be a bad idea. you can use CD/DVD's or thumb drives depending on the amout of stuff you select to save.
I have run chkdsk to fix errors in safe mode, which doesn't seem to have fixed this. Still getting error7
.
about twice a day.
Also run dell diagnostic on the hd which found no errors.
.
The device,harddisk1/D has a bad block is the message, which presumably refers to my one and only hd.
.
Any recommendations for a program that will copy the whole hard drive including os onto a new drive.
.
I assume this is the easiest way of dealing with this problem..
shesagordie
12 Elder
•
46017 Posts
1066
0
Posted August 7th, 2008 19:00
hary uk
You'll need a imaging utility, similar to either Acronis True Image 11 Home or Acronis Migrate Easy 7.0
First, install the new drive as the secondary, image the exsisting C:/ to it. Immediately shut the system down, switch the cable connectors, to make the new hard drive the master and see if the system boots correctly. Boot the system with only the new hard drive connected.
Remember to leave the original drive disconnected.
Before cloning a hard drive, be certain that existing drive has no corruption or virus on it, as these will be transfered to the new hard drive.
You can use disk management to partition and format the old hard drive to use as addititional storage, if you so wish.
Note: Seagate/Maxtor hard drives have a free copy of Acronis, that is included in their retail boxed drives or can be downloaded from Seagate's site for use with their OEM hard drives. This copy of Acronis can only be used with either a Seagate or Maxtor hard drive.
A hint: Read the Acronis manual before imaging the drives.
Bev.
===================================================
Please don't send me questions about your system by DCF Messenger.
Post the issue in the appropriate Board, where they will be answered.

Davet50
6 Operator
•
14442 Posts
1066
0
Posted August 4th, 2008 17:00
If you are continuing to get these errors then the drive can indeed be failing. If under warranty I would recommend getting the drive replaced. Or even if not the same would apply
As to your question none exists that I am aware of.