UNSOLVED

jon_8300

updated

22 years ago

J

jon_8300

5 Posts

0

18621

February 24th, 2005 03:00

Kind of Dead 8300

Here is the issue: My Dimension 8300 won't power on. There are no LEDs on in the back and there is no beep code.
  • I Have switched power cables,
  • surge protectors, etc.

I was pretty sure we had a dead power supply until, ah ha, I noticed that the pwr LED on the motherboard was solid green..Has anyone seen this and if so I'd appreciate any advice. Don't want to start ripping guts out.

j
 
 
 
  • The Sweede

    16 Posts

    303

    0

    Posted February 24th, 2005 03:00

    Sounds exactly like the symptoms which suddenly struck my 8300 down two or three weeks ago. Turned out it was a bad motherboard. Check my story on a thread started two weeks ago (search for "8300 Death").
     
    Best of luck.
     
    Bob
  • jon_8300

    5 Posts

    303

    0

    Posted February 24th, 2005 10:00

    Yikes! How did you isolate that as the issue. I am holding out hope that I have a bad fan or maybe the power switch is toast.
     
    Thanks again for your help.
  • danjane

    205 Posts

    303

    0

    Posted February 24th, 2005 11:00

      You might want to swap out power supply for a know working one.  Several computers built around 10/03 have had power supply failures.  The flea power works (5v) but will not give the 12V to power the system.  You would be the first 8300 to have this problem but a psu is cheaper than a mobo.

    Link:

    http://forums.us.dell.com/supportforums/board/message?board.id=dim_other&message.id=219360

  • jon_8300

    5 Posts

    303

    0

    Posted February 24th, 2005 16:00

    That fits with the symptoms, however I bought this pre- 10/04. I think I'll try replacing the on Mboard battery (just a hunch since it is a consumable) and try the power supply as well and then start playing around with the mobo options.

    I shoulda done that EE degree instead of American Studies!!

    Thanks for your help.

     

  • jon_8300

    5 Posts

    303

    0

    Posted February 24th, 2005 20:00

    Thanks. Similarly, I left my computer on over the long weekend and came back to a dead box...

    I have one other really wierd symptom to report (in case anyone has similar...) I got a dell chat guy on and he suggested

    1.) reseating the power cable connecting to the mobo. this did nothing.

    2.) Disconnected all drives and removed the memory.

    3.) tried to power on. After about 90 seconds the fans spun up!! I thought I was home free. I powered down, put the memory back in (left the drives disconnected) and there was nothing for a while, but then I got intermittent moments where the fans started up. The tech felt this was dangerous for the CPU so I unplugged. He felt power-supply. I will try that and if it does not work, MoBo, and if that does not work I'll get a Mac.  Will post the result. 

  • BrikFace

    35 Posts

    303

    0

    Posted February 24th, 2005 20:00

    Well, it could still be any of a dozen things but what leads you to rule out fried or partially fried cpu? Maybe you had the same consequences to your powered-up weekend as I described above, in which case you would be checking into psu, mobo _and_ cpu/heatsink fan before goinMac(tm). (Edit)-- Argh I guess checking mobo is for all purposes checking cpu (unless u have no mobo on hand to swap but u do have another cpu to try...)

    --
    BF

    Message Edited by BrikFace on 02-24-2005 04:55 PM

  • BrikFace

    35 Posts

    303

    0

    Posted February 24th, 2005 20:00

    For what it's worth, I just had very similar symptoms with an 8400. Apparently what happened was: I uncharacteristically left the box running for 2-3 days at a time over about a 2 week period, during the last such extended power-on period the heatsink fan failed without any warning in software and the cpu toasted. Strange thing is, all was ok at the time of my last power-down. But the damage to the cpu had apparently been done and the next attempted power-up saw me dead in the water (no backpanel indicator lights, just like you)... Upon replacing the cpu we thought we were home free-- only then could we see the bootup sequence report the dead fan. Hmmm, still wondering if this is exactly what happened with me but maybe this will point you in a direction with answers.

    A funny lesson out of all this (if my re-creation of events is correct)-- always subject a new system to all the stresses you can think of before you are within 3 or 4 months of warranty expiration. I had sort of half-consciously been following this rule (putting it thru performance tests, working out all drives, etc,.), but if I had been doing it fully consciously I would have tried out the extended power-on periods much sooner (I basically don't like the idea of running the new superfast comps for days on end, but they _are_ supposed to handle it, and it's a key way to smoke out iffy components that will just hit you later). Lucky for me I was still within warranty (barely). Hope u are too.

    --
    BF
  • jon_8300

    5 Posts

    303

    0

    Posted February 24th, 2005 21:00

    I think you are right. Wishful thinking is getting the better of my logic.
  • The Sweede

    16 Posts

    303

    0

    Posted February 25th, 2005 10:00

    You are exactly where I was. I first replaced PSU with no change in symptoms, leaving me with the MOBO, CPU choice. Not having a spare handy for either one, I purchased the mobo ($68 vs $200+) and to my surprise, resolved the issue. I had really thought it was the CPU, since fans, switch, little green led, etc. were still functional on bad mobo.

    Anybody need an 8300 PSU or clean (but non-functional) 8300 mobo?

    May 03 8300 Dimension
    3 GHz Northwood, 1.5Gb, ATI 9800 Pro, SBLive
    A01 BIOS updated to A07 after MOBO replacement
    350 W antec PSU (spare Dell 250 W PSU)

  • BrikFace

    35 Posts

    68

    0

    Posted February 25th, 2005 14:00

    Sweede your problem may well have been the cpu. When you swapped the mobo that included a new cpu, right? My point to jon was that if he didn't want to spring for a whole new mobo it might be worthwhile to just try a new cpu since so many of these dead system problems in 8300s and 8400s seem to be coming down to cpu/cpu fan issues.

    --
    BF