UNSOLVED

wld123architect

updated

19 years ago

0

9909

June 25th, 2007 14:00

Dimension 4600 Motherboard

My dimension 4600 has recently gone down.  Even with it connected to a an expensive USB power supply and surge protector I believe the motherboard is out.  I wasn't sure at first, because PSU fan was operating and CPU fan that is plugged into motherbaord was also operating, but I was getting no other response from the system - no diagnostic lights, no power light only the green lighted cylinder light for the hard drive.  Talked with Dell tech support for hours and they convinced me it was PSU.  Installed a new PSU provided by Dell and nothing changed.  After further conversations they feel it is the motherboard.  It is to arrive this pm.  Are there any tricks to this installation, jumper settings, etc. becasue I have heard that the installation instructions that are provided are lacking.
Thanks.
  • moonl33

    19 Posts

    162

    0

    Posted June 25th, 2007 16:00

    well, since you already talked to dell tech, it might be your motherboard, coz if your hdd works, then its not the psu, hard drive or... hmmmm... the heat sink maybe... dont really know coz you didnt give us enough details.
  • 162

    0

    Posted June 25th, 2007 17:00

    There is no hard drive activity when the computer power is turned on, only the indicator light on the front cover of the machine.  On the 4600 there are two lights on the front cover the power light and the hard drive light.  The power light does not come on.  The system never boots up.  The monitor clicks on only to go off again within about 3-4 seconds.  The only visible activity is the initiation of the psu fan and the cpu fan and the indicator lights on the keyboard for cap locks, num locks flash.  There is a small green light located near the front panel I/O connector (J9G1) on the motherboard that stays a solid green.  The heat sink does warm up in a minute or two, but there is no cylinder crunching sound or information being relayed to the monitor.  The 4600 also has the ABCD indicator lights on the rear of the machine for help in diagnosing a problem.  All four of these lights are not working.  They all appear to be black.
  • shesagordie

    12 Elder

    •

    46017 Posts

    162

    0

    Posted June 25th, 2007 20:00

    wld123architect

    Exchanging the motherboard is a fairly easy swap-out, just read the guide here and here, printing them for a reference, may help.

    Bev.






    ===================================================
    Please don't send me questions about your system by DCF Messenger.
    Post the issue in the appropriate Board, where they will be answered.
  • 162

    0

    Posted June 26th, 2007 12:00

    thanks for the links.
  • shesagordie

    12 Elder

    •

    46017 Posts

    162

    0

    Posted June 26th, 2007 20:00

    wld123architect

    You're Welcome. :)

    Bev.






    ===================================================
    Please don't send me questions about your system by DCF Messenger.
    Post the issue in the appropriate Board, where they will be answered.