UNSOLVED

zappcatt

updated

16 years ago

Z

zappcatt

2 Posts

0

2866

August 16th, 2010 13:00

630i and Crossfire under Windows 7 x64?

Is anyone successfully running Crossfire under Win 7 x64?

I have been running a single 5850 for a couple months, even being able to run Eyefinity(SWEET). I can not afford a whole new machine, so I decided to set up a Crossfire system and then when I buy a new machine I could bring them over.

I have had ZERO success getting it running.

Since these are newer cards, there are no "Dell optimized" drivers to use. I have read that the only way to get earlier Crossfire setups was to use the Dell specific drivers. Is that correct?

 

@DellCares says that Crossfire is fully supported.

 

Windows Device manager recognizes both cards are installed.
ATI Catalyst Control Center lists both cards, one being listed as active and other disabled. If I plug a monitor into the second card, it is thus enabled and able to drive a monitor(but never Crossfired) Eyefinity does not work across the 2 cards, so this does not benefit me at all. 

 

I have:

Fully uninstalled all ATI drivers to let Win reinstall everything fresh.

I have swapped Crossfire bridges.

I have swapped card positions.

I have restarted with only 1 monitor connected, I have restarted with all 3 monitors connected as duplicates, I have restarted with 3 monitors in Eyefinity.

 

It seems to me that the Dell "hacks" made to the Motherboard/bios do not work under Win 7 x64, or do not work with these new cards.

 

Needless to say, I am very dissapointed.

  • kevink37

    139 Posts

    242

    0

    Posted August 16th, 2010 13:00

    The only way to get crossfire to work on the 630i is with dell supplied ati cards and dell drivers as far as I know.  You should head on over to www.my630i.com and ask but I'm pretty sure that's the way it is.

     

    Kevin

     

  • Susan.Cobbs

    1 Message

    242

    0

    Posted January 2nd, 2011 17:00

    The only way to get crossfire to work on the 630i is with dell supplied ati cards and dell drivers as far as I know.  You should head on over to www.my630i.com and ask but I'm pretty sure that's the way it is.

     

    Kevin

     


    Many thanks to your description! It's very detailed.
  • markksheets

    1 Message

    242

    0

    Posted May 20th, 2012 08:00

    I am in the same situation. I read if you upgrade the bios it will work. So far it doesn't. Windows see both cards all monitors Catylist sees both cards and all monitors. I don't even see the option for crossfire and when I create a group in only gives me the option of two monitors. I see rthis is an old post if you ever figured it out, help me out please.

     

    Mark

  • Davet50

    6 Operator

    •

    14442 Posts

    242

    0

    Posted May 20th, 2012 09:00

    See the post from Kevink37. unless you are running the Dell drivers Crossfire will not work. This has been a flaw in  the system from launch.  Again the folks at my630i may have more insight.