Latitude 7350 Detachable - Keyboard switches off when positioned to angled mode.
As per the title when the keyboard is laying flat on the table it works as usual, however if I angle it up and attach to the bottom of the tablet part (also hiding the pen) the keyboard ceases to work, this has suddenly started happening in the last week and worked fine previously.
Returning the keyboard fully flat activates it again.
Appreciate any ideas on why this is happening and how to fix it.
An internet search offers (and I think it is not the likely answer)...
This is a known issue with the Latitude 7320/7350 Detachable folio keyboard: when you fold it into the raised “angled” typing position, the stiff bonded fabric can prevent the keyboard’s rear magnets from holding against the tablet, so the pogo connection can break and the keyboard appears to switch off. Dell’s documented fix is to work the folio fabric loose so it can bend properly.
Try Dell’s break-in fix
Detach the tablet from the keyboard.
Close the folio fully over the tablet, letting the keyboard’s magnets find and align with the tablet magnets.
Flip the keyboard back into the angled/raised position.
Lift the rear edge slightly and press down gently on both sides so the tablet magnets can attract the folio.
Repeat the folding/opening action several times. Dell says manually manipulating and folding the folio loosens the fabric enough for it to remain magnetically attached in angled mode.
Check the pogo connection
With the tablet flat on the keyboard, lift it off and inspect the pogo pins and alignment guides on both tablet and keyboard for lint, debris, or a bent pin.
Reattach it squarely: lower the tablet onto the keyboard and ensure the pogo connectors are aligned and firmly seated. Dell’s manual specifically calls for a firm pogo connection.
Test in the flat keyboard position first. If it works flat but cuts out only when angled, it is almost certainly the folio/magnet geometry rather than a driver problem.
If it still cuts out
Update Windows, then install the latest Latitude 7350 Detachable BIOS and input/keyboard firmware/drivers from Dell Support.
Restart, detach/reattach the keyboard, and test again.
If the keyboard loses power even when flat, or the angled position still disconnects after the break-in procedure, the folio assembly may be defective—contact Dell support for a keyboard replacement, especially if under warranty.
Do not force the rear fold or glue anything; the issue is excessive stiffness of the factory-bonded fabric, and repeated gentle flexing is the intended remedy.
@anne_droid Thanks yes I think it is a different issue and almost something similar to the opposite. When the magnets on the rear of the keyboard attach to the tablet then the keyboard stops working, when the keyboard is laying flat then it works ok.
The magnets seem to attach strongly and also the pogo pins also seem to attach well and strongly.
anne_droid
6 Operator
•
2631 Posts
•
9681 Points
1
0
Posted October 15th, 2026 10:05
Hi
An internet search offers (and I think it is not the likely answer)...
This is a known issue with the Latitude 7320/7350 Detachable folio keyboard: when you fold it into the raised “angled” typing position, the stiff bonded fabric can prevent the keyboard’s rear magnets from holding against the tablet, so the pogo connection can break and the keyboard appears to switch off. Dell’s documented fix is to work the folio fabric loose so it can bend properly.
Try Dell’s break-in fix
Detach the tablet from the keyboard.
Close the folio fully over the tablet, letting the keyboard’s magnets find and align with the tablet magnets.
Flip the keyboard back into the angled/raised position.
Lift the rear edge slightly and press down gently on both sides so the tablet magnets can attract the folio.
Repeat the folding/opening action several times. Dell says manually manipulating and folding the folio loosens the fabric enough for it to remain magnetically attached in angled mode.
Check the pogo connection
With the tablet flat on the keyboard, lift it off and inspect the pogo pins and alignment guides on both tablet and keyboard for lint, debris, or a bent pin.
Reattach it squarely: lower the tablet onto the keyboard and ensure the pogo connectors are aligned and firmly seated. Dell’s manual specifically calls for a firm pogo connection.
Test in the flat keyboard position first. If it works flat but cuts out only when angled, it is almost certainly the folio/magnet geometry rather than a driver problem.
If it still cuts out
Update Windows, then install the latest Latitude 7350 Detachable BIOS and input/keyboard firmware/drivers from Dell Support.
Restart, detach/reattach the keyboard, and test again.
If the keyboard loses power even when flat, or the angled position still disconnects after the break-in procedure, the folio assembly may be defective—contact Dell support for a keyboard replacement, especially if under warranty.
Do not force the rear fold or glue anything; the issue is excessive stiffness of the factory-bonded fabric, and repeated gentle flexing is the intended remedy.
Kind Regards
anne_droid