hpvpp

updated

2 years ago

H

hpvpp

1 Rookie

•

6 Posts

•

2 Points

0

581

October 28th, 2024 22:54

Latitude E6420 shows DVD-RW as read-only

My system has a DVD-ROM, but I needed to be able to burn CDs.  I could not find a replacement, but there was a DVD-RW from a E6410 model and it looked identical in the photo so I (naively) thought that it would fit. 

After some adjustments to the outside of the unit, it did fit, but the BIOS insists on it being read-only.

I have not been able to find a relevant setting to that effect, at least not one that was meaningful to me.

Even so, the utility Disks (I am running Linux/Ubuntu) does recognize the unit as a DVD-RW.

Any help would be very much appreciated.

  • ejn63

    12 Elder

    •

    31844 Posts

    •

    156262 Points

    0

    0

    Posted November 16th, 2024 11:53

    Yes. More likely, the CD laser has been used far more than the DVD laser -- and has failed as a result.

  • ejn63

    12 Elder

    •

    31844 Posts

    •

    156262 Points

    0

    0

    Posted October 28th, 2024 23:10

    Any firmware is only going to be able to use a CD-R/RW/+R/+RW as a boot medium if it's been properly written -- there's no such things a a writeable CD/DVD at the firmware level.

    You will need CD/DVD writing software for whatever Linux distribution you have.

  • hpvpp

    1 Rookie

    •

    6 Posts

    •

    2 Points

    0

    0

    Posted October 30th, 2024 06:04

    I apologize for not giving adequate information.

    Here are the relevant sections of lshw

    humphrey@Gummitch:~$ sudo lshw
    [sudo] password for humphrey: 
    gummitch
        description: Laptop
        product: Latitude E6420
        vendor: Dell Inc.
        version: 01
        serial: 1CB23R1
          capabilities: smbios-2.6 dmi-2.6 smp vsyscall32
        configuration: boot=normal chassis=laptop uuid=4c4c4544-0043-4210-8032-b1c04f335231
    [...]
            *-raid
                 description: RAID bus controller
                 product: 82801 Mobile SATA Controller [RAID mode]
                 vendor: Intel Corporation
                 physical id: 1f.2
                 bus info: pci@0000:00:1f.2
                 logical name: scsi0
                 logical name: scsi1
                 version: 04
                             clock: 66MHz
                 capabilities: raid msi pm bus_master cap_list emulated
                 configuration: driver=ahci latency=0
                 resources: irq:27 ioport:40d0(size=8) ioport:40c0(size=4) ioport:40b0(size=8) ioport:40a0(size=4) ioport:4060(size=32) memory:e2e40000-e2e407ff
    [...]
               *-disk
    [...]
               *-cdrom
                    description: DVD-RAM writer
                    product: DVD+-RW AD-7930H
                    vendor: Optiarc
                    physical id: 1
                    bus info: scsi@1:0.0.0
                    logical name: /dev/cdrom
                    logical name: /dev/sr0
                    version: 100A
                    capabilities: removable audio cd-r cd-rw dvd dvd-r dvd-ram
                    configuration: ansiversion=5 status=nodisc
    [...]

    I assure you that there is a disk in the device.

    Why is the system not recognizing the disk?

  • ejn63

    12 Elder

    •

    31844 Posts

    •

    156262 Points

    0

    0

    Posted October 30th, 2024 23:51

    If the disc is blank, it has no filesystem on it to mount -- this is completely normal. Or is there a filesystem on the disc?  If there is, and the drive doesn't read it, it's relatively old if it came with that system -- and may be defective.

  • hpvpp

    1 Rookie

    •

    6 Posts

    •

    2 Points

    0

    0

    Posted October 31st, 2024 07:29

    @ejn63​ Any suggestions how I can test the drive for being defective?

  • ejn63

    12 Elder

    •

    31844 Posts

    •

    156262 Points

    0

    0

    Posted October 31st, 2024 11:29

    If the disc has a UX-readable filesystem on it but the system won't mount it, the drive is faulty.

  • hpvpp

    1 Rookie

    •

    6 Posts

    •

    2 Points

    0

    0

    Posted November 8th, 2024 06:10

    @ejn63​ It was a plain music CD (purchased in a shop)

  • hpvpp

    1 Rookie

    •

    6 Posts

    •

    2 Points

    0

    0

    Posted November 16th, 2024 02:36

    I now have a Matshita DVD+/-RW which works.  Initially it failed to read a music CD and the advice I got was that the device might need a firmware update .  However, thatt seems to me a quite unrealistic idea for a basic device like a CD/DVD read/writer.  Would you agree?

  • hpvpp

    1 Rookie

    •

    6 Posts

    •

    2 Points

    0

    0

    Posted November 16th, 2024 23:50

    @ejn63​ okay, that makes sense.  Thank you.