UNSOLVED

OffLimit

updated

8 years ago

O

OffLimit

5 Posts

0

11044

May 17th, 2019 02:00

Area-51m, power adapter and power slot

I just buy Area51m, which have 2 power adapter and 2 power slot. I heard there is designated slots for each power adapter, small one, go to the small slot (not physically small but the slot that supposedbly have lower wattage input). Please clarify. Thnx before.

  • jphughan

    11 Legend

    •

    13985 Posts

    •

    79931 Points

    10160

    0

    Posted May 17th, 2019 07:00

    The Setup and Specifications document (link below) does not differentiate between the two connectors in the Setting Up section or the Back View section, so it doesn’t seem to matter which one you plug into which port. Link: https://www.dell.com/support/home/us/en/04/product-support/product/alienware-17-area51m-laptop/manuals

  • Eimy_B

    6 Operator

    •

    4365 Posts

    5597

    0

    Posted May 17th, 2019 14:00

    Hi @OffLimit

     

    As the system manual says: Your computer ships with two power adapters, and it will operate normally with one power adapter connected. For maximum gaming performance, it is recommended to connect the two adapters. Only use adapters supplied with your device, or Dell-approved adapters to power your device.

     

  • OffLimit

    5 Posts

    10101

    0

    Posted May 19th, 2019 00:00

    Yes i read the manuals as well, they don't differentiate.

    But also i heard someone have the laptop and connect in the wrong plug and have problems after 3-4 months of usage.

    Is there anyway to make sure of this, or this is already the right place ?

  • U2CAMEB4ME

    6 Operator

    •

    6245 Posts

    10091

    0

    Posted May 19th, 2019 04:00

    Welcome to the Dell Community  @OffLimit 

    The 2 power ports are in parallel and it does not matter what port is used.

    In parallel the Voltage stays the same but the Amps are added. 

    PTotal = P1 + P2  

    Use one of the AC adapters supplied but when needed add the second for more Power/Wattage.

    Best regards,

    U2

  • jphughan

    11 Legend

    •

    13985 Posts

    •

    79931 Points

    10093

    0

    Posted May 19th, 2019 04:00

    One user having problems isn’t a solid data source, especially since I find it hard to believe that the user can be certain that their problems were caused by switching AC adapter slots. I think the most certainty you’ll get is from Dell’s official documentation that I’ve already linked. It doesn’t make sense that Dell would have assigned specific ports to specific AC adapters without clearly marking them that way. A design that didn’t make that requirement clear and damaged the system would just result in a lot of warranty replacements (and therefore cost) to Dell and a lot of frustrated users.

  • Mike8704gt

    1 Message

    9662

    1

    Posted August 3rd, 2019 19:00

    So that being said, there can be a power supply developed to power the laptop with one single power brick and one  cord, I mean not for traveling but for easy home use. I don't see why that was not an option from the start since this laptop is more a desktop replacement then w laptop. Come on how many people does dell see carrying this beast on an airplane? It's. A single power supply should be an option.

  • bellacoo

    7 Posts

    8585

    0

    Posted October 13th, 2019 17:00

    let me know if u find one safe power supply what can replace for me to carry 2 bricks that will be awesome

  • RAF65

    137 Posts

    8533

    0

    Posted October 15th, 2019 09:00

    Hi

    When I travel by plane once or twice per year both laptop and power adapters are placed in my cabin suitcase. So carrying two of them it's not too bothersome. At least for me.

    I would avoid using one high power supply - excessive overheating causing damage and loss of warranty.

  • 8515

    0

    Posted October 15th, 2019 15:00

    It's not a technical problem.  It's a compliance one.  The reason for two power supplies is due to government regulation.  Manufacturers cannot make a power supply adaptor that is rated higher than 330W.  Since the draw of the laptop is higher than that... they must use two PS's to work within the legal requirements.

  • RAF65

    137 Posts

    6334

    0

    Posted October 16th, 2019 01:00

    Ok. I didn't know about it. Thanks for explanation. For me it doesn't change anything at least for the time being. I have to use two ones. I rather doubt there is a possibility of using one high power supply adaptor.