UNSOLVED

Sohirim

updated

10 months ago

Closed

S

Sohirim

1 Rookie

•

2 Posts

0

303

October 18th, 2023 23:21

AW2721D light of the stand broken

I tried calling support several times a few months ago to get help. Unfortunately, I was only mocked by your support and it was claimed that I had dropped the monitor, which is absolute nonsense and a bold insinuation of a company which has received over 600 euros for a monitor from me.

The problem:

The stand of my AW2721D has at some point stopped glowing, I thought it was the software but it was not. When I touched the monitor lightly, the light of the stand started to flicker but as soon as I let go of it, the light goes out. So there is a loose contact there. Of course, the monitor did not fall down and is firmly on my table. I asked for help and a solution (possibly a new stand) but I was only mocked. The so-called technology professionals only said that I had dropped it. How can it be that a 600 euro monitor after less than a year the lights no longer work? After all, you pay for the optics with Alienware and there is nothing left of that now. I hope there is a more decent support here than by phone and email. Iwas so shocked from the support that i had no more power to call you or write you because of the way the Support handled this.

(edited)

  • Chino de Oro

    11 Legend

    •

    8554 Posts

    •

    47161 Points

    0

    0

    Posted October 19th, 2023 00:02

    There are four gold plated connectors on the back of the monitor.  Make sure that they have proper contact with four matching connectors of the stand.

  • Sohirim

    1 Rookie

    •

    2 Posts

    0

    0

    Posted October 20th, 2023 18:36

    @Chino de Oro​ 

    The Monitor just "clicks" in there is no room for better contact

  • user_78f905

    1 Rookie

    •

    1 Message

    •

    2 Points

    0

    0

    Posted January 20th, 2026 16:33

    I have found a solution. It is basically the pogo pins not being able to connect as the metal posts that hold the weight of the monitor on the bracket of the stand gets misaligned. To fix this all you need is a thick sheet of paper from any packaging. you will need to disassemble your stand a bit. 

    First take you monitor off the stand. Now open all the screws in the stand mount in picture 1.
    Sandwich a thick sheet of paper between the plastic and metal bracket make sure its long enough to cover these marked screw. 
    Now screw through the sheet of paper. 
    Leave an excess flap like the last pic. 
    Now your stand will fit fully SNUG and the pogo pins will connect too.