UNSOLVED

rlightbourne

updated

22 years ago

0

31753

April 15th, 2004 03:00

Win98 reinstall problem

Background:

I have XPST500 which came with boot drive hooked to Promise Ultra 66 hard drive controller card, later upgraded to Promise Ultra 133. Am having great difficulty re-installing Win98SE OEM to the Promise Ultra 66 card using the Win98 OEM CD and floppy startup disk that came  with the puter.

No difficulty in re-installing to the motherboard IDE controller socket, but that is a tired little beastie that runs at 33Mhz, four times slower than the Ultra 133, and I discovered, to my chagrin, that when W98 is installed via the motherboard socket, it does not work if connected to the IDE1 socket on the Ultra 66 or Ultra 133 controller card.

Foreground:

After much trial and tribulation I have succeeded in getting Win98 to begin installing while connected to the Ultra 66, and the 34 of the 40 minutes of installation have now passed.  However, in the last six minutes of the install, my XPST500 is yelling at me with "File could not be found" messages.  Among files reported as "not found" in the directory C:|WINDOWS\SYSTEM\PRECOPY are:

dhcpcsvc.dll; icmp.dll; ienpstub.dll; inetmib1.dll; ipcfg.dll, networks, protocol, iphlpapi.dll, qosname.dll, msafd.dll, rapilib.dll, rnr20.dll, mslocusr.dll, routetab.dll, rpcltc3.dll, rpclts3.dll, THis is not quite a complete list.

Questions:

Is this "file not found" series of error messages a fatal flaw that means I should give up on the present installation ?  Will the re-install be okay if I complete it and then recover the files not found through using Extract on the .cab files on the CDROM ?    Is there any log kept of files not found, since I did not start making a list until four or five "not founds" took place. 

Will *really* appreciate guidance on these issues.

RL

  • DELL-Stephen S

    2 Intern

    •

    1396 Posts

    3017

    0

    Posted April 16th, 2004 19:00

    RL,

    Thank you for visiting the Dell Community Forum.

    All of the files you are listing are most likely in the CAB files on the Windows 98 CD (in x:\WIN98 – x: being the drive letter for your CD drive). When the system can’t find these files, point it to x:\WIN98, again x: being the drive letter for your CD. You may need to delete the Windows install and start over again to properly install these files.

  • 3017

    0

    Posted April 17th, 2004 02:00

    Many thanks, Stephen... will tryb
  • mcregge

    6 Posts

    3017

    0

    Posted June 5th, 2004 18:00

    This is closest topic to my problem. Came home from business trip to find that kid's computer (Dell Dimension L500c) would not start. Computer could not find system.ini file. So I reinstalled windows 98SE. Now I can't get internet traffic of any kind. The computer will connect to my dial up provider and to my cable internet wireless base station just fine, but every attempt to access the web produces "the page cannot be displayed....yada yada yada." Also, e-mail access doesn't work with Outlook Express.

    Following advice on another board, I (thought) I reinstalled intel chipset drivers, but no change. What do I do next?
  • osprey4

    6 Operator

    •

    34230 Posts

    3017

    0

    Posted June 6th, 2004 23:00

    Please start a new thread. When you post back, please clarify whether you have cable or dial-up internet service.
  • mcregge

    6 Posts

    3017

    0

    Posted June 7th, 2004 08:00

    Ok. I did. Thanks.