I got my RAID setup with the XPS from Dell. I am reading other threads that say the RAID drivers are included with the final release of VISTA.
All I know is that I tried to upgrade last night and got a memory error and the system halted. I think that was from some compatability issues with running software. I am going to try and boot the system up clean and try to upgrade again.
It depends. Vista has RAID drivers for some controllers pre-installed. However, if it does not and your RAID manufacturer has no Vista drivers yet, you will most likely not be able to install it.
I havetried 3 times now. AAAAARG. Vista upgrade advisor said it was an issue but that it would upgrade. Every time vista gets to the last part it wont boot. At least it let me roll back to Xp. I think it is the raid issue. Every thing else checked out.
Please help us. I tried installing the new driver in xp. I ran the exe file and it installed. Then I attempted to insall Vista. 3 hours later I was left with the same result as before. I had to roll back to XP.
Earlier in the night before the drivers were released I contacted Dell Tech support. They directed me to Nvidia drivers and told me to put them on a floppy and install by hitttng F6 when Visa gave me the option. I tried twice and never had that option. Any help would be welcomed at this point.
unzip the drivers and put them on the root of the floppy, in otherwords, no folders, just the drivers.
Start your Vista install, when you get to the white box that asks where you want to install Vista, highlite your c drive and click "other options" and look for install drivers, or something to that effect, pop in your floppy and click that option. It should show you the available drivers on the floppy that are compatible with your version of Vista. Click to install the sata raid controller, and one more sata driver, not sure which it is called. Once the drivers are installed, Vista should install. One hint, if you have more than 2 gigs of ram installed, remove all but 2 gigs untill Vista installs.
I am sorry to say that once again I never get the option to install drivers. There is never a box in the lower left corner on installation. I followed your advice to the letter and after combatability check it just starts installing. I am installing Vista Ultimate if that matters. Thanks for your time
I just cleaned my raid drive, essentially wiping it clean, and went to bios and picked the feature that said reset to factory defaults, changed my boot sequence to cd rom, put my vista disk in and did a complete clean install with no problems at all, been using it for the past week.........
kaps77
6 Posts
391
0
Posted January 31st, 2007 16:00