I decided to replace 40 gb with 160, I changed the cable settings, both on cable select, had many problems with install. I made a 100 GB and a 60 GB partition
Fist tried to install copy of XP PRO, was not recognizing boot sector at first, then finally loaded, but subsequent loads did not recognize boot sector.
I reloaded recovery disk that came with dell and all loaded fine.
It now takes about five minutes for the window's screen to load and there are only a few programs on my new install... Firefox and AVG..
I guess my question in all of this is, when i want to install windows fresh on a dell computer, is there anything special I need to do, or can I just install the cd..
It actually seems a simple process, but not sure if I need to do any other step..
As long as your drive partitions are setup properly and you can get to a command prompt easily with a boot disk, then their shouldn't be an issue with getting Windows installed. Just boot off the Windows cd and walk through the menu. I recommend the standard NTFS format over the quick format.
Gegor, your Hard Drive is reading wayyyy too slow. If you are still working on this problem. (I realize you posted almost a week ago) then try a different IDE cable, try changing the drives from Cable Select to Master / Slave with slave set on the center connection. The bios should be set to auto detect the drives and have no problem identifying them. If still going slow, then there's probably an issue with the IDE controller or something else on the motherboard.
spiritrunner
37 Posts
205
0
Posted June 20th, 2006 19:00