My inspiron 8200 is locking up about 10 seconds after the Window3s XP window starts up. The three little lights are rolling accross the screen and then - bam- they lock up. The computer will not react to anything at that point except the power button which will only turn it off. When I try to turn it on again, same thing. HELP
Boot into Safe Mode by pressing F8 while booting up
Try
1 Last Known Good Config
2 In Safe Mode boot into XP and try a System Restore
If you can`t get into Safe Mode I think you will have to do a repair
A repair won't lose any data, other than Service Pack 1/2, any Windows Updates and unsigned drivers, which will need to be re-installed afterwards.
Stay offline to do a repair and do not go online again without a firewall enabled. After repairing XP, install Service Pack, firewall and then you must install all Critical Updates next.
How to Repair XP
Boot up with the XP CD in the drive and let Setup run. Go past the first "R" repair option by pressing Enter just as if you're doing a clean install and you'll eventually come to an option to "Repair an existing installation". Select this one.
OK I still cannot start up. When I try to start in the Safe Mode, it shows installation of all drivers but when it gets to "agp440.sys", it freezes up. Any other suggestions???
OK now I am thoroughly prepared to throw my computer out the window. When I hit the "R" to go to the recovery mode. It tells me to insert the floppy disk that is labeled "Recovery Mode". I have changed the boot up line up to be only bootable from the CD. When I hit esc, windows starts to load, it loads everything it is supposed to (I think) and the screen locks up on the blue screen with "Setup is starting Windows" at the bottom of the screen. Do I have, like an, alien living in my computer?
1 Remove all unnecessary hardware and cards like network ( Not video)
Try to boot up XP normally
2 Check that your RAM is seated properly.
Then if you have more than one stick of RAM (256MB or more) take one out and try again. If it does not help or makes things worse swap the sticks and try again. This will identify if you have a bad stick.
OR
You can put either of these free programs on a floppy and test the RAM
I am opening the window and dangling my laptop off the balcony. None of the above worked. It still stops at "agp440.sys". I do not have a floppy to make disks to. XP was already installed on my laptop when I got it and I cannot find a floppy install, maybe I didn't get one. Can I buy one from Best Buy or Circuit City?
dunedin
2732 Posts
196
0
Posted July 26th, 2005 23:00
A repair won't lose any data, other than Service Pack 1/2, any Windows Updates and unsigned drivers, which will need to be re-installed afterwards.
Stay offline to do a repair and do not go online again without a firewall enabled. After repairing XP, install Service Pack, firewall and then you must install all Critical Updates next.
Boot up with the XP CD in the drive and let Setup run. Go past the first "R" repair option by pressing Enter just as if you're doing a clean install and you'll eventually come to an option to "Repair an existing installation". Select this one.
Scroll way down page to
Windows Installation CD - Repair Current Installation