Have you given a shot with ESI 3.5 SCOM Management Packs for health monitoring of VPLEX (https://support.emc.com/search/?text=esi)? And 3.6 is planned for end of the year...
Maybe this process will help if you are looking for how to test sending/receiving the email from the VPLEX:
Goal
How to test if the Simple Mail Transfer Protocol (SMTP) server configured for call home is working. How to test the SMTP server configured for VPLEX callhome.
Environment
EMC Hardware: VPLEX Series
EMC Hardware: VPLEX VS1
EMC Hardware: VPLEX VS2
EMC Hardware: VPLEX-Local
EMC Hardware: VPLEX-Metro
EMC Hardware: VPLEX-Geo
EMC SW: GeoSynchrony 5.0
EMC SW: GeoSynchrony 5.0.1
EMC SW: GeoSynchrony 5.1
EMC SW: GeoSynchrony 5.1 Patch 1
EMC SW: GeoSynchrony 5.1 Patch 2
EMC SW: GeoSynchrony 5.1 Patch 3
EMC SW: GeoSynchrony 5.1 Patch 4
EMC SW: GeoSynchrony 5.2
EMC SW: GeoSynchrony 5.2 Patch 1
EMC SW: GeoSynchrony 5.2 Service Pack 1
EMC SW: GeoSynchrony 5.2 Service Pack 1 Patch 1
EMC SW: GeoSynchrony 5.2 Service Pack 1 Patch 2
EMC SW: GeoSynchrony 5.2 Service Pack 1 Patch 3
EMC SW: GeoSynchrony 5.3
Resolution
1. Discover the SMTP server address and the email sender address being used by ConnectEMC.
Service @ManagementServer:/>cat /opt/emc/connectemc/ConnectEMC_config.xml
Note: SMTP server IP address is found in ConnectEMC_Config.xml
3. Enter the following commands and press the return/enter key where you see . You do not need to enter the text in italics.
helo localhost
response should be as follows:
250 OK
mail from: VPlex_CKM12345678 @EMC.com
Note: Sender email address is found in ConnectEMC_Config.xml. We use this email address to ensure relaying is permitted correctly.
response should be as follows:
250 OK - mail from VPlex_CKM12345678 @EMC.com rcpt to:
response should be as follows:
50 OK - Recipient
data
response should be as follows:
354 Send data. End with CRLF.CRLF
Subject: Testing SMTP server
This is the body of my test email
.
Note: The full stop (above) denotes the end of the email body. You need to type this to finalize the email.
response should be as follows:
250 OK
quit
4. Watch your inbox to check if an email is received from VPlex_CKM12345678 @EMC.com with the subject "Testing SMTP server". If you receive no email or if you receive any errors during the process then there may be a problem with the SMTP server.
ankur.patel
2 Intern
•
286 Posts
2726
1
Posted April 24th, 2012 12:00
One can setup email alerting
/opt/emc/connectemc, run connectemcConfig or just edit ConnectEMC_config.xml
you can run ./connectemcConfig -help to see the parameters