UNSOLVED

Latif_ee7dc4

updated

20 years ago

0

2452

October 4th, 2006 12:00

Alerts

I have been doing some testing on Openmanage IT Assistant 8.0 and noticed that if I pull one of the main power plugs at the back of a poweredge server, I get an instant message.
What I don't understand is, if a faulty hard drive is detected, it does not inform us instantly, yet hours later.
Why is this?
  • 92

    0

    Posted October 4th, 2006 22:00

    It should not work like that. Barring network traffic and mail congestion I would make sure you are at the latest BIOS, ESM/BMC and PERC firmware. I would also make sure you are running the latest version of OMSA.
  • OMNavigator

    291 Posts

    92

    0

    Posted October 5th, 2006 04:00

    Apologize for lot of questions, but these will help to understand your queries better...
     
    (a) Are you sure your SNMP settings are correct (on both ITA station and the poweredge server being managed)?
     
    (b) What are discovery (ITA -> Discovery and Monitoring -> Discovery Configuration) and status ((ITA -> Discovery and Monitoring -> Status Polling Configuration) intervals that you configured?
     
    (c) Also could you confirm whether you are trying to see both the alerts (power and hard drive failure) in Alerts->Logs screen of ITA?
     
    (d) For the system where you pull the main power plug, does it have a redundant power supply or is it getting power shut down? What is the alert you see for that -- power supply redudancy lost or is it system down alert?
     
    (e) What is the kind of fault with the hard drive?
     
    Thanks.