Director : DA-1A
Interface : C
Target ID : 0
Disk Group Number : 0
Vendor ID : SEAGATE
Product ID : SX173404LC
Product Revision : CHET_73
Serial ID : 3CE10F42
Disk Blocks : 143374737
Block Size : 512
Actual Disk Blocks : 143374737
Total Disk Capacity (MB) : 70007
Free Disk Capacity (MB) : 820
Actual Disk Capacity (MB) : 70007
Hypers : 16
I am not seeing any property which tell me about the drive type(i.e Fibre channel or SATA) and speed of the drive.
you can refer to following link to see how seagate numbers their drives. this usually applies to emc drives too. in this case they have altered the number to have ST prefix rather than usual SX
EMC drives may come from Seagate and other vendors ...
Seagate uses ST as the prefix for all the drives they produce.. Since EMC uses a "modified" firmware on the drives you have a different prefix (SX) ..
Please note that drives may come also from IBM as in the following output...
clst01t/root> symdisk -sid 022 show 16b:db
Symmetrix ID : 000xxxxxx022 Director : DF-16B Interface : D Target ID : B Disk Group Number : 0
Vendor ID : IBM Product ID : IX35L146EFDY10-0 Product Revision : IBM146F Serial ID : ECWYHKWE
Disk Blocks : 286339876 Block Size : 512 Actual Disk Blocks : 286749475 Total Disk Capacity (MB) : 139814 Free Disk Capacity (MB) : 2368 Actual Disk Capacity (MB) : 140014 Hot Spare : False
I think that the best answer is always ask your local friendly CE .. He will supply you all the infos you need
If the vendor is segate then If i check the product ID, It ends with FC if drive is FC . Please check the below output. Same thing applies for SATA... I checked the segate site , if the drive is SATA, then it ends with NS,AS,SATA,CE,RK,SV
Director : DF-1A Interface : C Target ID : 0 Disk Group Number : 1
Vendor ID : SEAGATE Product ID : SXT14685FC Product Revision : T146155 Serial ID : 3LN198JA
Disk Blocks : 286749475
1. Is it possible to do same thing apply for IBM disks for whcich we find for segate disks? 2. Is there is any other vendor disk will be there other than segate and IBM in symmetrix.
mlee2
108 Posts
406
0
Posted May 21st, 2009 12:00
Did you see the thread "Determine drive speed from ECC or SYMCLI?" http://forums.emc.com/forums/thread.jspa?threadID=59112&tstart=0 ? This may answer some of your questions.
Best Regards,
Michael.