If you don't have RAID, then there should no need to install the Matrix Driver, but you need to make the following changes,
F2 to enter the Setup.
Arrow down to Drives, then enter.
Arrow down to SATA operation, then enter
Arrow to RAID Autodetect / ATA and click enter to select.
Then click ESC to save and exit.
Bev.
=================================================== Please don't send me questions about your system by DCF Messenger. Post the issue in the appropriate Board, where they will be answered.
Okay, thank you for your answer. But I read that this BIOS setting could decrease the performance. It´s even written inside the BIOS, that Dell recommends to keep the RAID setting even with just one harddrive, for better performance. It´s no problem to install the Intel Matrix driver, but I just want to be sure that it doesn´t cause any problems or conflicts because I just have one harddrive.
There should be no problems with using the RAID driver, with a single hard drive, but you will need an internal floppy drive to install the driver when it's requested.
Bev.
=================================================== Please don't send me questions about your system by DCF Messenger. Post the issue in the appropriate Board, where they will be answered.
Message Edited by shesagordie on 02-17-2007 03:35 PM
It won't install nor function without multiple drives configured for raid. So you can try to install it, but it won't, so you will not see decrease in peformance.
shesagordie
12 Elder
•
46017 Posts
217
0
Posted February 16th, 2007 18:00
Arrow down to Drives, then enter.
Arrow down to SATA operation, then enter
Arrow to RAID Autodetect / ATA and click enter to select.
Then click ESC to save and exit.
Please don't send me questions about your system by DCF Messenger.
Post the issue in the appropriate Board, where they will be answered.