UNSOLVED

KUCAN

updated

12 years ago

K

KUCAN

1 Rookie

•

17 Posts

0

4340

December 19th, 2014 06:00

Cluster Management IP address...vRPA 4.1...how to change it

I recently built 2 vRPA clusters with 2 vRPA's at each site.  (Virtual Recover Point 4.1 connection to VNX storage at each site..2 sites)

I've been told that I need to change the IP of one of the Clusters.

The Clusters have been connected but no Consistency groups are other configuration has taken place.

How/Where the heck do I change that IP?...and possibly the netmask as well.  Seems simple enough .

Cheers

  • KUCAN

    1 Rookie

    •

    17 Posts

    2826

    0

    Posted December 19th, 2014 07:00

    Ok..it's a bad day lol.   Realized all I had to do was simply Putty into the RPA directly.  Detached from the cluster and modify the Cluster.   Easy menu to navigate.

  • KUCAN

    1 Rookie

    •

    17 Posts

    2826

    0

    Posted December 19th, 2014 08:00

    Found it.

    Under Other Operations.

    Cheers

  • forshr

    2 Intern

    •

    1126 Posts

    2826

    0

    Posted December 19th, 2014 08:00

    If you make the change via the RP DM System Modification Wizard you can guarantee that the change will be made uniformerly across all the RPAs in each cluster.

  • KUCAN

    1 Rookie

    •

    17 Posts

    2826

    0

    Posted December 19th, 2014 08:00

    I forgot to mention.  When I run RecoverPoint Deployment Manager I don't see the "System Modification" wizard.

    Just the RecoverPoint/SE Wizard and Connet Cluster wizard.

  • KUCAN

    1 Rookie

    •

    17 Posts

    2826

    0

    Posted December 19th, 2014 08:00

    Where do I find that wizard?  This is for a vRPA deployment and not physical.

    After I changed the mgmt IP and rebooted all the RPA's the old IP came back for some reason.  The new IP didn't take.

    So that wizard is probably what I need.

  • forshr

    2 Intern

    •

    1126 Posts

    2826

    0

    Posted December 19th, 2014 08:00

    This is probbaly because you did not detach and re-attached the RPA(s) to the cluster. The Systems Modification wizard is one of the wizards you can run using the RecoverPoint Deployment Manager (DM) Tool.

  • hbib

    8 Posts

    2090

    0

    Posted September 30th, 2019 02:00

    j 'ai la meme probleme, t peut m'aider apres l'ajout d'adress ip et l'attacher de cluster il ma demande de redemarrer ensuite tous le config est perdu

  • Idan

    4 Apprentice

    •

    675 Posts

    1908

    0

    Posted October 27th, 2019 06:00

    Hi there,

    Make sure to leverage Deployment Manager as it's the only supported way to perform this operation, if the operation fails, raise a SR with support.

     

    Hope that helps,

    Idan