
UNSOLVED
M
mschoonmaker
6 Posts
0
7851
June 7th, 2004 13:00
M5200n Slows down to creep after ~20 pages!
I bought a M5200n printer for some personalized newsletter (statement size) printing.
For the most part, the printer works fine. I have had to upgrade the memory (maxed it out at 320MB) to support the "overlay" function, which works well but does not solve my problem.
I have found that after 20 pages or so of printing this statement sized newsletter (fairly graphics intensive), the printer's speed slows to a crawl. Although I have not made specific measurements, the first 20 pages or so come out at _around_ 30 pages per minute. After the initial 20 pages, the printer slows to about 5 or 6 pages per minute (painful!).
I should also add that if I print only 20 or so, then let the printer sit for a few minutes, then print again, the second print job will be bac to the fast output (again, for the first 20 pages or so). This tends to point _perhaps_ to a temperature issue, but this is only a guess.
Any ideas?
TIA,
Mike
Responses (1)
Solutions (0)

d3sp
470 Posts
125
0
Posted July 7th, 2004 13:00
If it is the case then you answered your question already.
When printing small sized paper the fuser part which are not touching the paper will get overheated after printing some pages, thus the printer will slow down in order to not damage the fuser after about 20 pages.
It will not happen if you are printing on full size paper Letter/A4.