UNSOLVED

jhs51

updated

21 years ago

J

jhs51

6 Posts

0

7113

November 2nd, 2005 20:00

1600n under Lan Manager

We have just installed a Dell 1600n printer on our small peer-to-peer network, which runs Windows XP. It works absolutely fine across the network when used as a Windows printer. However, we also use an old DOS-based accounting package, and we need to be able to print to the 1600n as LPT3:

Our old HP printer, on a Netgear print server, worked fine with the command 'Net use lpt3: \\pserver\p1' The 1600n is at a fixed IP address of 192.168.21.10, and its hostname is set via the web interface as 'DellPrinter', so what should our 'Net use...' command be in order to print to it? I have tried a number of 'Net use..' commands, and just get the message 'The network resource type is not correct.'

I'm sorry if I'm missing something totally obvious, but at the moment I'm stuck.
  • shadowlynx

    151 Posts

    227

    0

    Posted November 3rd, 2005 13:00

    you might find this link useful ...
     
    also, make sure you have the printer shared on your pc.
  • shadowlynx

    151 Posts

    227

    0

    Posted November 3rd, 2005 14:00

    thats where the problem lies, this print server does not actually put out a name, it actually installs as a local printer on a network port, you need to go into the printer properties and share the installed printer, (it will then have a computer name (yours) and a share name (printer name)  i know it sounds strange, but should work.  
  • jhs51

    6 Posts

    227

    0

    Posted November 3rd, 2005 14:00

    Thanks.  This is well worth knowing, but it doesn't really answer my particular issue: the printer is directly plugged into the network using its own built-in print server, it is not connected to any one of the PCs, so I can't share it from the PC.  So when I use the Net use command, I need a computername and a sharename.  I'm assuming the computername is the hostname that I set on the TCP/IP tab of the printer's management page (ie 'Dellprinter'), and that then there should be some sharename which I use to refer to the actual printer, but I can't work out what it should be.

    When I used the old HP on a Netgear printserver, the the computername (ie the name of the print server box) was set to 'pserver', and the sharename was P1 (ie parallel port 1 on the Netgear, which is the name that the Netgear exposed to the network), and this worked fine, using the command 'Net use lpt3: \\pserver\P1'.  I think I now need to use something like

    'Net use Lpt3: \\Dellprinter\something',

    but I can't work out what that something should be.  Sorry if I wasn't clear.

  • jhs51

    6 Posts

    227

    0

    Posted November 3rd, 2005 20:00

    Thanks very much. As you say, it seems totally strange, but it works perfectly - it even runs properly using Terminal Server across our VPN. I don't think I'd have ever worked this out.
  • shadowlynx

    151 Posts

    227

    0

    Posted November 7th, 2005 11:00

    glad to hear it worked.    have a good one.