Dell Precision Tower 7910 Power light comes on but fails to boot BIOS
Hi
I had a motherboard replaced by dell after it blew about 6-7 months ago.
It was running fine for a few months and then just as the parts warranty ran out it suddenly it failed to boot. After dell told me that they were unable to help as the part was out of warranty and stock. I left the PC in the corner for about a month or two. I then randomly tried to power it on and it suddenly worked. Everything was fine it booted up a couple of times and I assumed the problem had somehow fixed itself. About a week later it's suddenly failing to boot again. The symptoms are as follows:
Press power on.
Power switch light comes on. A brief glimmer of light passes through the hard disk read /write light & fan kicks up.
Then fan stops nothing ever appears on screen no BIOS no other sign of life. no keyboard lights.
The Power button light then remains lit solid white. And on the motherboard there is a green flashing LED with LSI HB LED written below it.
If anyone has any information on how to solve any of this I would be truly grateful,
Check this manual, page 51 has the supported memory configurations.
Now, about finding the faulty ram... one way would be to remove one good module, and use that slot to test the rest of the ram one by one (assuming that the moment you put a faulty inside, the system would be again not working as before).
Try replacing the coin cell battery. Buy a new coin cell battery in any store that sells batteries. It's a cheap fix. Manual-- Dell Precision Tower 7910 Owner's Manual
LSI HB LED >> it's the heartbeat led... blinking green means the lsi controller is perfectly fine. You will find a similar led on raid controllers ( usually green when ok, but there are makers that use red ) and in some cases directly on motherboards to signal that the mb is healthy .
In this specific case obviously is signaling that the lsi controller is working as it should
When you try to access BIOS, be sure to press F2 immediately upon startup. No waiting for Dell logo or keyboard light. The same applies for accessing F12 Boot Menu. If it you've done that already and/or still doesn't allow BIOS access, MB may be bricked. If it does allow BIOS access, it should allow Boot Menu and Diagnostics access. Arrow down to Diagnostics and run it.
mazzinia_
6 Operator
•
1534 Posts
•
6405 Points
5236
1
Posted April 25th, 2022 11:00
Good , glad that things are moving forward quite well
https://dl.dell.com/topicspdf/precision-t7910-workstation_owners-manual_en-us.pdf
Check this manual, page 51 has the supported memory configurations.
Now, about finding the faulty ram... one way would be to remove one good module, and use that slot to test the rest of the ram one by one (assuming that the moment you put a faulty inside, the system would be again not working as before).