I'm trying to install Windows NT on a PE2650 with a PERC 3Di RAID controller. During the initial setup (whether I specify an additional driver or not), I get a BSOD with the following message:
Before the installation, I upgraded the RAID firmware to 2.8. The RAID driver I'm using is version 2.8 as well. I successfully installed Windows 2000 on the server and ran the update CD. This recommended downgrading the RAID firmware but the firmware is still at 2.8.
Can anyone provide a link to the firmware and driver that I should be using if you think that's the cause of the problem or if you have any other ideas, your suggestions would be greatly appreciated. I really need to get this server up and running as soon as possible.
Windows NT won't install on a system with 512MB or more. The install mode in the bios just 'kills' the memory quantity so you can install the OS. Once the OS is installed you disable the install mode and you'll have access to the complete memory quantity (as far as a 32-bit OS can go of course).
DarylCMS
3 Posts
142
0
Posted September 9th, 2008 08:00
It looks like I've found the solution, guess I should have searched these forums first before posting.
The solution was to set the OS Install mode to ON in the Bios.
Thanks anyway :)