UNSOLVED

ianbeyer

updated

20 years ago

I

ianbeyer

1 Rookie

•

4 Posts

0

8685

June 6th, 2006 21:00

RAID-5 reconfiguration - bigger, badder...

I recently needed to expand storage on my Exchange server, which was configured for RAID-5 on 3 disks, 2 of them 18GB, one of them 36 (using only half of it). I added 2 more 36GB disks and told the Array manager to reconfigure for RAID-5 on the three 36GB disks and to remove the two 18GB disks. It told me I couldn't do that because of "insufficient space" despite my choosing a virtual disk size that was within the range given.

I decided I'd try to go ahead and reconfig it on all 5 drives and then try and remove the two 18s later. after 5 hours of churning, it was reconfigured to the size I wanted, but it was using all 5 disks, pretending the 36GB disks were only 18GB. When I then tried to reconfigure again with just the three 36GB disks, it again told me I had "insufficient space" to do that operation, which should yield the same virtual disk size on 3x36 instead of 5x18.

I'd like to recover at least one of those 18GBs to use in another array that's got a single 36GB and a bunch of 18s, so I can put that 36GB to better use.

What in the heck is going on?
  • pboyd04

    59 Posts

    254

    0

    Posted June 6th, 2006 21:00

    The method that I would chose for this is to remove one of the 18GB drives, then replace it with the 36GB drive. Wait for the Array to rebuild and then do the same for the final drive. Then you can reconfigure the VD to take up the whole space.
  • ianbeyer

    1 Rookie

    •

    4 Posts

    254

    0

    Posted June 7th, 2006 01:00

    Well, the other problem is that I can't prepare any of those disks for removal - the option to do so is grayed out... what do I do, just yank it out? I also don't necessarily need a 5x36 array on that machine - 3x36/5x18 for 72GB is more than plenty.
  • 69cougar

    1 Message

    254

    0

    Posted June 13th, 2006 14:00

    I had to fail a drive by pulling it out & restarting, then stick the new drive in & rebuild for each drive I wanted to replace. You have to do it one at a time, or you lose your raid. It's time consuming, but it works. On a 1600SC, however, you won't be able to extend the volume into the free space. All you'll be able to do is create a new volume in the RAID manager.
  • pboyd04

    59 Posts

    254

    0

    Posted June 14th, 2006 02:00

    Thats not entirely correct. It depends on your RAID card if you can expand the volume or not.