We have an R730XD 24+2 chassis with SSD's both in the front and rear slots. We want to have the rear slots controlled by a PCI-E H330 controller, and the front to be controlled by a mini-mono HBA330, with software RAID that we'll set up later. Two major questions arise from this.
1. We were able to connect the rear BP to the H330 with a straight-to-90 SFF-8643 SAS cable, but it's a weird fit and we'd like to find a part number for a straight to straight version of the same cable.
2. When we make this connection with our existing cable, we get a message saying "CBL0009: Backplane 0 connector A0 is not connected."
No amber lights, everything appears to work, but I don't like seeing this message. Can anyone provide assistance?
Yes, it is possible to boot from a Dell H330 PCIe RAID controller connected to a 2-slot rear backplane on an R730XD server. However, there are a few considerations and steps you need to follow to ensure it works correctly:
Update Firmware:
Update the H330 firmware and the R730XD BIOS to the latest versions using Dell's support site.
Configure RAID:
Enter the H330 RAID configuration utility (usually by pressing Ctrl+R during boot) and create a bootable RAID volume on the drives connected to the rear backplane.
Adjust Boot Order:
Enter the BIOS/UEFI setup (press F2 during boot) and navigate to the boot settings. Add the H330 PCIe device to the boot order.
Install OS:
Boot from your OS installation media and install the OS onto the RAID volume created on the H330.
Install Drivers (if needed):
Some operating systems may require additional drivers for the H330. Load these during installation if prompted.
Potential Issues:
If the H330 is not recognized in the boot order, double-check the BIOS settings and ensure the RAID volume is properly initialized.
If the OS installer doesn't detect the drives, verify the RAID configuration and ensure the correct drivers are available.
with kind regards Martin/ Liebe Grüße Martin
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
This is a server I purchased recently and originally only had an H330 mini (which I swapped for an HBA330 mini) and added the H330 PCIE. The H330 was in the wrong riser, so I relocated it to Riser 1, but still have the same issue. The only difference is that I am using the cable with part # 08KX9H. Isn't that electrically equivalent to the 8RJM1 cable or is there some other difference?
DellMartinS
Moderator
•
3885 Posts
•
25816 Points
0
0
Posted August 11th, 2025 07:57
Yes, it is possible to boot from a Dell H330 PCIe RAID controller connected to a 2-slot rear backplane on an R730XD server. However, there are a few considerations and steps you need to follow to ensure it works correctly:
Update Firmware:
Configure RAID:
Ctrl+Rduring boot) and create a bootable RAID volume on the drives connected to the rear backplane.Adjust Boot Order:
F2during boot) and navigate to the boot settings. Add the H330 PCIe device to the boot order.Install OS:
Install Drivers (if needed):
Potential Issues:
with kind regards Martin/ Liebe Grüße Martin
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
DELL-Martin S
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell