UNSOLVED

hmaynord

updated

22 years ago

H

hmaynord

2 Posts

0

5451

January 29th, 2005 13:00

checking a new scsi drive for errors before adding it to raid array

We have a 1500SC with a PERC3/SC raid controller and 3 SCSI drives.
 
I want to increase to 5 drives.
 
I bought 2 additional drives, which are used.  I simply want to run some type of error check on the drives before I add them to the array.  I cannot see anything like this in Array Manager.
 
When I go into the SCSI bios with Ctrl-A on boot, all it sees is the raid controller -- it does not see the separate drives.
 
When I go into the RAID bios with Ctrl-M on boot, it sees the separate drives, but I don't see any option for formatting or otherwise checking the drive for errors.  However, I can do something called a "Clear" on the individual drive, and I have done that and it ran fine, but I do not know if that simply wipes all of the data off of the drive, or if this Clear also checks all of the drive, including the free space, for errors.  That this Clear function ran successfully on each of the used drives is reassuring, but I still would like to run some type of simple error check on the drive before I add it to the Raid.
 
Thanks.
 
Harris   
  • 154

    0

    Posted February 13th, 2005 16:00

    Download the Elite hard disk diagnostics program. There are two versions: a windows GUI and bootdisk version that is not as polished round the edges as the former, but cuts to the point and does a fine job of it too.

    Install your drives into the system and restart using the bootdisk. Choose to log the results (on the floppy) and perform a comprehensive test. This should tell you the condition of the drives.

    Regards

    Popolou