I have a strange issue. I have an R640 with 6 disks. It came with RAID-0 configured which I want to change it to RAID-5. In iDRAC storage page, I initiated to delete the RAID-0 but in the job queue, it's stuck at 1%. Then I realized it's in Lifecycle controller. So I exited it out and it rebooted. After waiting for 1/2 hour, it still shows 1% in iDRAC. So I proceeded to boot into RAID config page in the console, deleted the RAID-0 and created a RAID-5. After some time, RAID-5 was initalized successfully and the virtual disk shows it's ready for use. I then went back to iDRAC but it still shows the 1% pending job to delete the RAID-0. The option to cancel is disabled. iDRAC shows the disks are online but there is no virtual disk. To see if the virtual disk is available, I installed ESXi which was able to see the virtual disk. Now my concern is the pending job to delete the RAID-0 is stuck and it may come back at some point to erase my RAID-5. Is there a way to kill the job? I understand it's an I/O job that should be disrupted but in this case, it's no longer valid.
During a firmware upgrade, the code is staged on the server and requires a reboot to complete the upgrade which takes approximately 45 minutes. But if an emergency or lack of time requires the server to reboot and bring up immediately, the job queue can be cleared with a single iDRAC command and can be rebooted immediately.
Solution:
Clear the iDRAC job queue using one of the following:
DELL-Erman O
Moderator
•
2984 Posts
•
14874 Points
0
0
Posted July 24th, 2025 13:10
Hi, hope this will be helpful:
Clearing the iDRAC job queue on Dell servers.
Fact:
During a firmware upgrade, the code is staged on the server and requires a reboot to complete the upgrade which takes approximately 45 minutes. But if an emergency or lack of time requires the server to reboot and bring up immediately, the job queue can be cleared with a single iDRAC command and can be rebooted immediately.
Solution:
Method 1:
Run the following command through racadm:
<dracIP>is the iDRAC IP address<username>is the username of the user<password>is the password for the serverNote: The
-roption is only needed when running remote, if you are running directly from the host OS this is not required.Method 2:
Run the following commands through SSH to iDRAC:
Note: The iDRAC is unable to process any other jobs during this time.
Hope that helps!
DELL-Erman O
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!