
UNSOLVED
Unhappy with the fan noise of your 600SC? I might have a solution for you
I might have discovered to reduce the fan noise of the 600SC to half. No cutting, splicing or pressing F1 key.
I did this and the noise is half or less of what it used to be. All you have to do is get the front fan for the 600Sc and replace your 120mm monster with the 92 mm front fan. Here is what to do.
- Get the replacement for the front fan from Dell. The part number is 2R911.
- You will see that the front metal plate and the prtotective grill are attached to the fan with black rivet like plastic tabs. If you look closely at the inner side of the tabs, they are like the push pin kind where once you push the rivet in, the end expands and locks the tab in place. Gently hit the middle raised portion to raise the pin like end of the tab. Once it is out you can pull the entire pin out.
- Repeat that for all the pins of the metal frame side and the protective grill side. Replace the grill of the fan on the side which had the metal plate. The reason to do that is because the front fan is mounted to pull air into the case where as the rear fan is supposed to pull air out of the case. So, swapping the grill makes the fan ready to be mounted so that it pulls air out.
- Remove your 120mm monster. The case has pre drilled holes for the 92mm fan. Use the 4 remaining mounting clips to mount the fan to the case. Connect the fan power cable to where the 120 mm fan was connected and Voila.
Now your 600SC makes half the noise. No splicing of wires or no F1 Keys for Fan not detected errors. Since you are using a dell fan, no voiding of warranty.
Now for the Disclaimer.
The 92 mm fan draws a lot less air than the 120 mm. So, if you have any concerns about heat do NOT do this mod. Please do not blame me for any issues you run into while attempting this. I am running 3 IDE hard drives in the server. If you are running SCSI drives, you might want to look at other options. This is still not as quiet as some of the desktop systems Dell sells. But if you want it that quiet, please buy that system and get rid of the 600SC because it is after all a server.
Message Edited by dvpatel on 10-03-2003 08:17 PM
Responses (1)
Solutions (0)

mandyrc
3 Posts
629
0
Posted January 29th, 2005 07:00
Well, is really stupid that Dell don�t provide a way to disable fans detection, but I do a mod that isn�t the better idea but can skip "F1 to continue and F2 to setup" when PowerEdge system not detect a fan. Is simply and I try to explain better as possible:
Using a cable like used to connect from cd-rom to audio card, I connect the center pin of the connector of back fan in the mainboard to the sensor ping of the processor fan (I suppose that you keep the Dell provided fan for microprocessor). Then repeat the same with the front fan connecto in the mainboard. With this mod you can cheat the Dell bios fan detection, system detect a back and front fan, jejeje, but really is detecting the microprocessor fan. And you not see the alert message and don�t have to press F1 or F2.
Please, this is only a cheat, I test it and work in my PE 600SC without problem. Is very important to check that you connect the cable in the correct pin. I'm not guilty If you not connect the cables in correct form. And is your responsability use or not this cheat.
Greetings
Mandy