I have a DELL PowerEdge 4400/600 server than won't bot up into the OS. When it is in the boot process it displays the informaion below and then the "Strike F1 to retry boot, F2 for setup utility" message is displayed and that is far as it will go. I listed the F2 Settings on page 2 of Setup, and listed some things that might be of importance. If you could PLEASE give me any help in knowing what to do to resolve this issue, I would be so grateful.
Sincere thanks,
Steve
-------- This appears on the screen when Server is started after the DELL logo is prompted. -------------
PowerEdge 4400/600 BIOS Version A03
Embedded Server management firmware rev 5.22
System backplane firmware rev 5.32
!!! *** WARNING. Firmware is out-of-date, please update
Power supply paralleling board firmware rev 2.36
In the F2 Setup screen, page 2 the settings are as follows:
Integrated Devices
USB = ON
Mouse = ON
Serial Port 1 = Auto
Serial Port 2 = Auto
Parallel Port = 378h
Parallel Mode = PS/2
Diskette = Auto
NIC = Enabled
NIC MAC Address = Not Present
On Board RAID = Off
Channel A = SCSI
Channel B = SCSI
Secondary SCSI = ON
------------------------------------------------------------------------------------------------------
Things that might be important to know:
1.)There are 3 power supplies, w/ each having a power plug. Should all 3 power supplies be plugged
in, or just one?
2.)There are 6 drive sections on the bottom. I'm not sure if there are 6 drives in there or not, but only
3 of them light up.
3.)There are 2 lights above the drive area, one having a lightning bolt icon above it that blinks orange,
and the other light has a fan blade icon above it that stays lit up solid green.
4.)Once the boot up process displays the "F1 to retry boot , F2 for setup utility" message, if I press
F1 after that it just redisplays the message again, and again everytime I press it.
5.)The Server is NOT hooked up to any network at all. I just have it plugged up by itself.
6.)I went into Setup an changed the NIC = Enabled to Disabled an rebotted and it didn't change
anything.
7.)Does the "!!! *** WARNING. Firmware is out-of-date, please update" message have any bearing
I did the BIOS update that you recommended and rebooted and it basically still has the same problems. Just like my 1st message explains, and stops after the "Press F1 to continue, F2 for Setup" message. What should I do from here? I really need to get this server up and running.
get to bios and check if you are using raid/scsi toggle thru the settings and boot after each setting change
i believe this is on page 2 of bios settings
i ahd the same problem till i playd with these settings
Hi, I had the same problem and as you said, playing with the different options of the "On BoardRAID" I made it work. In my case, I had 4 HD's and I wanted 2 containers with RAID1 (mirror), so I selected in the BIOS:
On Board RAID: RAID
Channel A: RAID
Channel B: RAID
Secondary SCSI: On
After selecting these settings, the server boot up and you can set up the RAID options by pressing "Ctrl-A". Note that you need to finish the "Container Scrubbing" process before installing the OS.
DELL-John K.
245 Posts
439
0
Posted October 20th, 2004 20:00
Below is a link to the downloads for the 4400. Update the system bios first, then the ESM firmware.
Downloads 4400