It was in perfect working condition and came with an Enterprise iDrac license. This was working well, and I could manage the service via the web interface.
I attempted to update the firmware using the iDrac web interface. I uploaded the BIN file for the iDrac update, and clicked install. This remained at 10% for over an hour and then appeared to hang and do nothing. I rebooted the server thinking that I would start again.
Obviously this didn't work, and I was greeted with an "Error initializing iDrac" error. The Lifecycle controller is now disabled and I'm unable to log into iDrac via the web interface or through SSH. Furthermore, there is no LED indicator on the iDrac.
I download the bootable Dell ISO thinking I could correct the broken update this way. It makes it to the BIOS update and then errors out.
I've done a fair amount of research online and it seems I either replace the motherboard (more than the total cost of the server!) or order an EMMC chip online and resolder it to the motherboard. This seems like the cheapest option and there is a video on YouTube from three weeks ago showing that this does work.
This was my first Dell server and it was running for 30 minutes before something as trivial as an update broke it. I've read that there's an option to place the firmware file for the iDrac on the SD card, however this only seems to work if the iDrac boots into recovery mode (flashing amber LED). My iDrac is not displaying any LED.
Can you perform a complete power cycle of the server by removing the power cable and connecting back after few minutes and check whether there is any change in behavior
I've since replaced the motherboard and all is well.
I'm trying to make sense of the correct update procedure now that the system is working again.
My iDrac is v1.57. Can I use the bootable Dell ISO to update everything at once automatically?
There seems to be many different ways to update firmware, and no general consensus on the order in which to update everything. The last thing I want to do is brick another board.
Can someone please clarify how to go about updating everything on this server correctly?
Your current iDRAC version is too old and assuming the server BIOS is also outdated, it is necessary to update it and iDrac to their latest versions. But you should not choose to jump from very old versions to the most recent versions so that the motherboard does not have problems. So don't use bootable ISO. You can click on BIOS and iDRAC on this page and then select the previous versions in order to update.
There are a lot of versions from 1.57 to the current version of the iDrac firmware. Do I need to update incrementally through every single one of these until the most recent?
I know this is a bit boring. Actually, you would have to do it in the suggested order. You can try not to do each one step by step, but at least you can try to update them by skipping two or three at a time. But remember that it is risky. I recommend not skipping more than three versions, especially for iDRAC and BIOS.
DELL-Erman O
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
You need to alter the update between iDRAC and BIOS like iDRAC -> BIOS -> iDRAC -> BIOS. This way we can ensure both FW are on same level any point of time and ensure there is no much gap between iDRAC and BIOS version
DELL-Charles R
Moderator
•
4730 Posts
•
25476 Points
1
0
Posted June 23rd, 2025 17:01
Hello,
I'm sorry, Dell does not have schematics, publicly available, and has never asked anyone to solder/desolder components.
While that information is possibly in engineering, it is not publicly available.
You can try it but I don't have any support available for that.
DELL-Charles R
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Accept as Solution’. ‘Thumbs up’ the posts you like!