I recently upgraded an Optiplex 7010 with 2x8gb DDR3 ram sticks and everything runs fine, except the ram is only running in single channel mode. I've tried using DIMM 1-3 and DIMM 2-4 with no difference. Is this just a limitation of the motherboard with 8gb sticks?
"dual-channel mode is always present when both memory channels are populated. however, for optimum dual-channel performance, the size of the modules must match."
I've got matched sticks in the right channels, and they're both showing up and running fine, but they're in single channel instead of dual channel.
Are the 2 modules (8GB each) the only memory, or do you have other modules also?
Exactly what are the brand and model of these modules?
Incidentally, the speed gain by having dual channel is very slight for most applications, so you probably wouldn't notice the difference if you do get it solved.
ok, did you first RTM read you manual to see how to populate the slots for 1x8GB? that is first
then pull the AC line cord, first. and then push power button 3 times for 1sec, until fans stop twitching.
now the PC is 100% dead, never hot swap ram or BOOM go broke. fast.
then put in the sticks in the correct slots A and B. do not guess, RTM. the book even tells you slot colors in most cases.
then power up system
and reset BIOS, hammer F2. and reset bios, (shows set bios to defaults) this will force a full DDR scan!
turn off PXE, feature in F2 BIOS, and make sure boot order is HDD0 SSD0 first.
then boot PC.
The 7010 MT has 4 DDR slots, (no pc stated by you, and not reading all 4 manuals to you)
MT page 14 states.
Memory modules must be installed beginning with the first socket. (means A1 i presume)
The memory sockets in your computer may be labeled differently depending on the hardware configuration. For example, A1, A2 or 1,2,3.• If the quad-rank memory modules are mixed with single or dual-rank modules, the quad-rank modules must be installed in the sockets with the white release levers.• If memory modules with different speeds are installed, they operate at the speed of the slowest installed memory modules.
given the words on page 14, put one stick on A1, white ended slot, then stick 2 in B1.
A means channel A
B means channel B
so done that way and resetting BIOS, you will get , dual channel operation.
just off hand(cant see inside your PC) you are not using the 2 white slots.?
outboard to inboard are (slots labeled as DIMM1,2,3,4 but in this order)
Alright, I think I may just have them in the wrong DIMMs. It's frustrating that the manual doesn't actually state which slots to use. I'll try swapping them later.
Ah, that could be your problem. Patriot memory and Kingston memory are no good and rarely works properly in dell computers. Nobody knows why, but rock musicians always recommend only crucial brand memory ... It's guaranteed to work with dells.
Patriot memory will NEVER work in any dell computers. Never ever.
@donm4599xI upgraded my 7010 MT with Patriot DIMM (4GB) and it worked all right.
I am not saying Patriot memory is always perfectly fine, but I am willing to challenge your claim it will never ever work in any Dell computer. It does work in my 7010.
EndoS
1 Rookie
•
4 Posts
6785
0
Posted December 4th, 2019 20:00
It says
"dual-channel mode is always present when both memory channels are populated. however, for optimum dual-channel performance, the size of the modules must match."
I've got matched sticks in the right channels, and they're both showing up and running fine, but they're in single channel instead of dual channel.