For this configuration, can the M.2 NVMe drive remain as the boot drive while a 7mm 2.5-inch SATA SSD is added for data? If the system currently has only the NVMe drive, which Dell SATA cable and drive caddy are needed, and are those parts specific to the 3060 Micro chassis?
I would appreciate any compatible part numbers or relevant service-manual references. The linked listing is in Vietnamese; the specifications can be read using browser translation.
I suspect the RED area (listed as 11 M2 SSD) is in use, the BLUE area is available for a HDD (shown as item 1).
2.5-inch HDD/SSD caddy (drive bracket) JMYPN The caddy that grips the sides of a 7 mm or 9.5 mm 2.5-inch drive; also referenced as compatible part JH960
No cable should be needed.
HDD caddy support / mounting bracket.
Often sold with the caddy; verify by chassis photo.
The small support piece screws to the motherboard and holds the caddy assembly in place. The service manual calls it the “HDD caddy support.”
Unfortunately I cannot establish where or how spare parts would be sourced for your situation.
anne_droid
6 Operator
•
2627 Posts
•
9672 Points
0
1
Posted October 30th, 2026 11:13
Hi
Hope this helps...
https://www.dell.com/support/product-details/en-gb/product/optiplex-3060-micro/overview
Taken from the manual.
I suspect the RED area (listed as 11 M2 SSD) is in use, the BLUE area is available for a HDD (shown as item 1).
2.5-inch HDD/SSD caddy (drive bracket) JMYPN The caddy that grips the sides of a 7 mm or 9.5 mm 2.5-inch drive; also referenced as compatible part JH960
No cable should be needed.
HDD caddy support / mounting bracket.
Often sold with the caddy; verify by chassis photo.
The small support piece screws to the motherboard and holds the caddy assembly in place. The service manual calls it the “HDD caddy support.”
Unfortunately I cannot establish where or how spare parts would be sourced for your situation.
Kind Regards
anne_droid