
UNSOLVED
Trunking Between VLANs on One Physical Switch?
My goal is to setup redundant bridging-firewalls between two VLANs on a single PowerConnect 3248. Is this possible? My bridging-firewalls are OpenBSD machines configured as bridges running pf (packet filter).
I was thinking it would be cool to use trunking to increase bandwidth as well as redundancy. I tried several configurations on my 3248, but nothing seems to work. The simpliest configuration that works is connecting a single OpenBSD bridge between VLANS 1 & 2 with no trunks.
Disconnecting one side of the bridge breaks communication between VLAN 1 & 2, which is expected behavior and proves all traffic must go through the filtering bridge to talk to different VLANs.
My setup:
VLAN1 -> Ports[13-50] (unused)
VLAN2 -> Ports[1-4] (client group 1)
VLAN3 -> Ports[5-8] (client group 2)
VLAN4 -> Ports[9-12] (bridges and trunk)
TRUNK1 -> Ports[9-10] VLAN[4,2] PVID = 4 (bridges listening to client group 1)
TRUNK2 -> Ports[11-12] VLAN[4,3] PVID = 4 (bridges listening to client group 2)
Bridge1 -> Port[9,11]
Bridge2 -> Port[10,12]
Is there a better way? Any pointers in accomplishing my goal will be much appreciated? Basically, I want to (1) create redundant bridges and (2) share load among those bridges.
Thanks,
Clint Pachl
I was thinking it would be cool to use trunking to increase bandwidth as well as redundancy. I tried several configurations on my 3248, but nothing seems to work. The simpliest configuration that works is connecting a single OpenBSD bridge between VLANS 1 & 2 with no trunks.
Disconnecting one side of the bridge breaks communication between VLAN 1 & 2, which is expected behavior and proves all traffic must go through the filtering bridge to talk to different VLANs.
My setup:
VLAN1 -> Ports[13-50] (unused)
VLAN2 -> Ports[1-4] (client group 1)
VLAN3 -> Ports[5-8] (client group 2)
VLAN4 -> Ports[9-12] (bridges and trunk)
TRUNK1 -> Ports[9-10] VLAN[4,2] PVID = 4 (bridges listening to client group 1)
TRUNK2 -> Ports[11-12] VLAN[4,3] PVID = 4 (bridges listening to client group 2)
Bridge1 -> Port[9,11]
Bridge2 -> Port[10,12]
[VLAN1] = network 1.1.1.0/24
/ \
/ \
/ \
[Trunk1] [Trunk1] = Ports 9,10 on 3248
| |
| |
[BR1] [BR2] = OpenBSD boxes running as bridges
| |
| |
[Trunk2] [Trunk2] = Ports 11,12 on 3248
\ /
\ /
\ /
[VLAN2] = same IP subnet as VLAN1
Is there a better way? Any pointers in accomplishing my goal will be much appreciated? Basically, I want to (1) create redundant bridges and (2) share load among those bridges.
Thanks,
Clint Pachl
Responses (2)
Solutions (0)

MiF_STIG
5 Posts
246
0
Posted May 5th, 2007 10:00