UNSOLVED

TAD01

updated

21 years ago

T

TAD01

8 Posts

0

20784

December 12th, 2005 17:00

Setting up network but cannot see workgroups

I've been searching for days and have tried several things (disabling firewall, ect) but can not seem to find out way I can not see the computers in my peer-to-peer network.  I know I have the connection, I have the folders shared.  I'm sorry if this has been covered but I've been going around in circles.  Please help direct me!
  • Jjpeters18

    49 Posts

    828

    0

    Posted December 12th, 2005 18:00

    you can always connect to them via name/ip address, for example goto My Computer make sure search bar is on and type in \\Tado1\c$ or 10.0.0.15\c$ etc. Then just map to that drive. Beyond that are you sure that both pcs are in the same workgroup?
  • TAD01

    8 Posts

    828

    0

    Posted December 13th, 2005 00:00

    I'm assuming that if both computers had the same workgroup name that when connected through a wireless network I should be able to go to my Wireless Network Place, click on view workgroups, both computers should be there.....is this correct?
  • 828

    0

    Posted December 15th, 2005 12:00

    are the two computers able to ping each other ??
    for a rapid response you can email me to techsupport4free@gmail.com
  • Suzbandit

    277 Posts

    828

    0

    Posted December 16th, 2005 00:00

    Sorry to ask a stupid question, but what does "ping" mean?

    Thanks

    :smileyhappy:

  • TAD01

    8 Posts

    829

    0

    Posted December 16th, 2005 16:00

    No I was not???
  • Jjpeters18

    49 Posts

    828

    0

    Posted December 16th, 2005 16:00

    ping is a DOS command that sends packets from a host to a client and confirms a response. You use it by going start run cmd (or command.com on older pcs) and typing ping (10.0.0.5) or (blipblop.com) etc.
  • Jjpeters18

    49 Posts

    829

    0

    Posted December 16th, 2005 16:00

    Actually I don't believe peer to peer gives both pcs an ip address, since the 2nd computer is using internet through the 1st and not talking to dhcp. Check ip config on both pcs, if only 1 has an address make sure it is set up to allow other computers to connect to the internet through it/connect it it period.
  • Jjpeters18

    49 Posts

    829

    0

    Posted December 16th, 2005 16:00

    Were you able to connect via \\pcname\c$ or via \\ip.address. .?
  • TAD01

    8 Posts

    829

    0

    Posted December 16th, 2005 16:00

    I tried the ping again and I am unable to ping the other computer.  I'm using a wireless connection, with a peer-to-peer.  The connection is excellent?!  I can ping my computer and see my computer on the workgroup but not the other????
  • TAD01

    8 Posts

    393

    0

    Posted December 16th, 2005 17:00

    I want to make sure that what I'm thinking is my ip address is shown when I ping?

    I get reply from: 169.xxx.xx.xxx  I do have one of the computers set to allow the network computers to use it's Internet connection but the other I do not.