My friend's 8500 has a 1300 WLAN mini PCI card in it. It suddenly stopped receiving any wireless signal at all. I've tried uninstalling the card and updating the drivers but it didn't help. It always says that there are no wireless networks available. I have no problems with my laptop, so it's not a problem with the access point.
Turn off the laptop then turn it over and you will see a little panel with one screw to open it. Open this up and you will see the card. It has two prongs holding it in place spread them VERY CAREFULLY only holding the card by the sides.
Now do it in reverse to reinstall it. Good luck
You might want to try to reseat the wireless card. If that dose not it might be a bad wireless card,do you have another wireless card that you could try in it?
It may even be easier than reseating the card...
I remember answering a service call once for someone who had the same problem with an 8500. After much diagnostic anguish, I remembered that there is a keyboard function that turns the wireless on/off.
It's keyed to the "FN" key on the 8500's keyboard. Try toggling that on and off.
On the 600m I'm on now, for example, the combination is "FN" + "F2".
I'm sure these on/off toggles are good for something, but I observe that they don't tell you how they're toggled except that your wireless suddenly stops working!
If you can't breathe life into the mini-pci, then insert a wireless PCMCIA card into the 8500's slot. See if that will work.
good luck,
Yes. It works ie. turns on and off, but I'm still getting no signal. I'm waiting to borrow a wireless card from a friend and will update you as soon as I do.
I also have an 8500, and am also having problems with wireless connectivity.
Last night my wireless connection dropped completely between 7 and 10pm, although my wife's iBook could still connect wirelessly, and I was able to connect via ethernet cable to the same router at that time. I have had similar problems intermittently for some time.
Any ideas? I get the feeling my 1300 minipci card is having trouble getting signal at peak hours, when network usage is high and signal strength correspondingly low. All help appreciated.
Look to local interference. Someone else's wireless router or 2.4ghz phone could be interfering. I would try moving your wireless router to a different channel - like 11. Log into the router as the admin and in the wireless section you should be able to designate the channel. The wireless computers should automatically follow.
jazzbone
6 Posts
510
0
Posted March 25th, 2005 15:00
Thanks for the suggestion. How do I reseat the card? Is it hard to get to?
No, I don't have another card.