UNSOLVED

SYSnotDEV

updated

8 years ago

S

SYSnotDEV

5 Posts

0

2121

April 3rd, 2019 15:00

VRTX R1-2210 failed to boot - HOSTG_flash_page_is_empty

We have a VRTX with the R1-2210 10G switch that was failing to boot.  The CMC web page shows "I/O module A1 failed to boot"  this is a R1-2210 switch module.  This happened after a full power cycle of the system, previously the system was online... 

  • CMC is at: v3.20
  • mainboard is at: v2.21
  • .R1-2210 is at: v2.0.0.75 

 

Can't connect to the switch:

  • $ connect -m switch-1
  • connect: acquiring remote port
  • (hangs here with no other output)

 

Serial console shows constant scrolling with:

“HOSTG_flash_page_is_empty: offset ##### exceeds flash limits.”  

 

Looks like the firmware was corrupt or bad image.  I am told the listed procedures were followed when the switch was updated.

 

Had to re-upload & re-flash the switch with xmodem.  Per insight from: 

https://www.dell.com/community/Networking-General/PowerConnect-2824-configuration-access-issues/td-p/5133177

 

Then switch was responding correctly.

 

And for good measure did a full shutdown and power removal.

All still good and now back to normal.  Wanted to post this to help anyone else that may encounter the same, or similar, issue!

  • DELL-Josh Cr

    Community Manager

    •

    9798 Posts

    •

    45341 Points

    1885

    0

    Posted April 3rd, 2019 16:00

    Hi,

    Thanks for providing the information. It is great when the community helps each other out.

  • rcoop133

    3 Posts

    750

    0

    Posted November 10th, 2020 11:00

    How did you connect to the switch to do the xmodem commands?

  • DELL-Josh Cr

    Community Manager

    •

    9798 Posts

    •

    45341 Points

    745

    0

    Posted November 10th, 2020 13:00

    Hi rcoop133,

    You can connect to the serial port of the switch through the cmc with the connect switch command.

  • rcoop133

    3 Posts

    706

    0

    Posted November 13th, 2020 07:00

    Thanks Josh. As the original poster stated, when the R1-2210 doesn't boot properly the serial connection from the CMC just hangs.

    I purchased a cable to connect to the serial port: WY835

    I have a different error:

    %HAL_hw_lion-F-SetInfModeAndSpeedFailed: Failed to configure ifIndex 5 speed 2 interface mode 3 status 1


    Any idea on how to fix this issue? Flashing the firmware via xmodem does not help.

  • rcoop133

    3 Posts

    701

    0

    Posted November 13th, 2020 07:00

    The solution was to pull the switch, remove the cover, and then remove the small battery (CR2032) and then replace it.

  • DELL-Josh Cr

    Community Manager

    •

    9798 Posts

    •

    45341 Points

    697

    0

    Posted November 13th, 2020 09:00

    Great that you got it resolved.