Replacing Dell 4032 and Ubiquiti EdgeSwitch 16 with Dell 5248F-ON questions
Hello all! I'm currently working on a project to phase out two Dell 4032 and two Ubiquiti EdgeSwitch 16's with two Dell 5248 switches. The current set sits between our two NetApp Vsan units and 3 VMWare hosts. The NetApps have two controllers per device and we currently have two NICs per controller set up in a lag config running to the Ubiquiti switches, so a total of 8 DAC cables. From the Ubiquiti Switches there are two ports(LAG) from each switch connected to our two 4032 switches that are in stacked configuration. Below is how I have the 5248 switches set up currently. Does anyone see any reasons this wouldn't work to replace the 4 switches?
5248 Switch 1
interface port-channel10 description "Netapp2 Controller 1 port-channel" no shutdown switchport mode trunk switchport access vlan 1 switchport trunk allowed vlan 102 ! interface port-channel20 description "NetApp1 Controller1 Port-Channel" no shutdown switchport mode trunk switchport access vlan 1 switchport trunk allowed vlan 102 ! interface ethernet1/1/1:1 description "VMWare Host 1" no shutdown switchport access vlan 102 flowcontrol receive off ! interface ethernet1/1/2:1 description "VMWare Host 2" no shutdown switchport access vlan 102 flowcontrol receive off ! interface ethernet1/1/3:1 description "VMWare Host 3" no shutdown switchport access vlan 102 flowcontrol receive off ! interface ethernet1/1/4:1 description "NetApp1 Controller 1" no shutdown channel-group 20 mode active no switchport flowcontrol receive off ! interface ethernet1/1/5:1 description "Netapp2 Controller 1" no shutdown channel-group 10 mode active no switchport flowcontrol receive off ! interface ethernet1/1/6:1 description "NetApp1 Controller 1" no shutdown channel-group 20 mode active no switchport flowcontrol receive off ! interface ethernet1/1/7:1 description "Netapp2 Controller 1" no shutdown channel-group 10 mode active no switchport flowcontrol receive off
Hello thanks for choosing Dell and welcome to our community. For us to help you the best that you send tech support your logs with an official ticket. https://dell.to/4eI7HnY The assist on the forum may be limited. However for now, what I can point out is that it looks like there's some misconfiguration. Can you tell us if your configuration is following this topology that I shared? Because there has to be some special configuration done on OS10 switches(S5248F). You can share your own topology diagram if you like for our better understanding.
Respectfully,
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
DELL-Young E
Moderator
•
5421 Posts
•
37 Points
0
0
Posted November 21st, 2024 08:03
Hello thanks for choosing Dell and welcome to our community.
For us to help you the best that you send tech support your logs with an official ticket. https://dell.to/4eI7HnY The assist on the forum may be limited.
However for now, what I can point out is that it looks like there's some misconfiguration.
Can you tell us if your configuration is following this topology that I shared? Because there has to be some special configuration done on OS10 switches(S5248F). You can share your own topology diagram if you like for our better understanding.
Respectfully,
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!