UNSOLVED

ecoty1

updated

17 years ago

E

ecoty1

6 Posts

0

1357

March 23rd, 2010 10:00

Networker and IBM TS3500 tape library

Anyone running networker on solaris 10 with back end IBM TS3500 tape library? Trying to determine how to configure the jukebox and verify drive mappings?

  • masonb

    445 Posts

    352

    0

    Posted March 24th, 2010 02:00

    If you are going to use jbconfig to configure the library you will need to compare the output of sjisn b.t.l (where b.t.l is the scsi address of the robotic) with the inquire output. This is the easiest way to see what device path is related to the element number of the drive within the jukebox. If you do not do this most people just answer the questions posed by jbconfig with the lowest numbered device path first and ascending up the list. This is not necessarily correct as jbconfig asks you to supply the path for Element 001 first and goes through the list that way. Element 001 in the jukebox does not necessarily correspond to the first drive the OS sees (a lot of the time the order is OK but you cannot assume this is the case as it depends upon how the drives have been cabled and which HBA's see them in the server).

    Comparing serial numbers reported in inquire and sjisn command will give you this and allow you to supply the correct device paths related to the prompts.

    Configuring via the GUI - all of this is handled automatically as the dvdetect and Robot Wizard do this for you.

    Regards,

    Bill Mason

  • amediratta

    2 Intern

    •

    2014 Posts

    352

    0

    Posted March 24th, 2010 02:00

    Are you following the correct steps and facing any issues? If yes, let us know the issue?

    The steps should be:

    1.     Connect the library on the server.

    2.     Solaris 10 would load drivers on its own and assign device path names.

    3.     Run Networker inquire command and see if the Medium Changer and all drives connected are visible in inquire command.

    4.     Run jbconfig command and choose Autodetected SCSI jukebox for SCSI/FC connect library. Alternatively, you can configure library through NMC GUI.

    Any issues, post it here.

  • bbeckers1

    2 Intern

    •

    205 Posts

    •

    6 Points

    352

    0

    Posted March 24th, 2010 02:00

    you can also use best of both worlds from GUI and command line jbconfig (I prefer jbconfig as it shows you what it does instead of just automatically doing it through the GUI) by first performing a scan for devices in the NW GUI (devices->storage nodes. select the server the library is configured for adn click scan for devices).

    Once robotics controller and tapedrives paths are known, then jbconfig from NW7.4 and higher will knwo exactly which devicefile belongs to which physical drive, so you just have to enter when it reports a certain devicefile which should already be the correct order.