UNSOLVED

rjmoeller

updated

20 years ago

R

rjmoeller

14 Posts

0

11348

August 28th, 2006 19:00

Dell 1704 FPV usb issues

We use the 1704 FPV monitor with the Optiplex GX280 pc here at work. On a few of the monitors we have had an issue where occasionally the usb hub does not recognize any usb devices that are plugged into it. We have figured out to clear the problem we power off the pc, disconnect the power and usb cables from the monitor for 30 seconds, then plug them back in and power the pc back up. Today I had a new problem that was cleared with the same fix. The problem I had was that the usb hub in the monitor was causing the system to bog down and lock up while booting, trying to access the boot menu, or even trying to navigate the bios. It would take atleast 2 minutes for it to get through the post to get into the bios or to the boot menu. Has anyone else seen this? Does anyone know of a cause for either of these problems and maybe even a permenant fix?
  • 236

    0

    Posted August 30th, 2006 15:00

    I have seen other posts where if you have a power outage, the USB will lock up when this happens.
    Try unplugging the power cord of the monitor from the wall, wait 5 seconds and plug back in and it should work.
     
     
  • rjmoeller

    14 Posts

    236

    0

    Posted August 30th, 2006 18:00

    I have already tried that and yes that did clear the problem.  My question is though does anyone know of a cause and or permanent fix for this?
  • rjmoeller

    14 Posts

    236

    0

    Posted November 8th, 2006 15:00

    We went out as part of a big update project and upgraded the bios to A08 on all 500 machines. Since this update was appilied we have had 3 more failures. Is there anyone else who is have these same problems? Is there a known or atleast suspected cause to the 1704FPv's flaky usb hub?
  • rjmoeller

    14 Posts

    236

    0

    Posted February 28th, 2007 13:00

    After going back through all of our call records for the past year I have found a common thread to all of the failures. All of the LCD's that we have had problems with have the same serial number down to the last 4 digits. This defective serial number range is MY-0H6304-47603-563-xxxx (xxxx being what changes). Dell refuses to admit publicly admit that there is a defect and to do anything but replace one by one on a on failure basis. Any of you out there who have 1704FPv monitors and have been having USB issues check your serial number, I bet it will be in this range.