
UNSOLVED
Closed
XPS m1730 BIOS update gone bad
Hi,
just did a routine BIOS update (I say routine because I update BIOSs all the time @ work & home when available and if they are worth it).
Well, update mine from A03 - A09, everything went well on the flash, but not so well on the reboot... I keep getting a memory error, one that seems to point out that I has defective memory.
Well, that doesn't make much sense, seeing as I've been using this laptop for nearly a year without any memory configuration changes. So now there's no way it will accept more than 1GB. I have 2x 1GB modules, and it doesn't matter which I put in what slot, it will only accept one, and then boot fine in Vista after that.
I can't even run the Diagnostics (through F5) as it says I don't have enough memory to run it... yet the BIOS sees 2048MB total & 2046MB left (as it always did).
Anybody seen this or am I looking at a tech fix?
Responses (3)
Solutions (0)
Well, seems I was just pretty darn unlucky & it was just a weird coincidence that the BIOS update seemed to have caused havoc with my RAM (or maybe there's new algorythms to check for memory health in the new BIOS revisions...) but I just finished testing 4 different other sticks of RAM from other Dells (some D830s from work) and 2x 1GB from those laptops worked flawlessly in my XPS.
I didn't try my sticks in those laptops, because once I knew mine were a bit flacky, I just decided to upgrade to 4GB anyways... Vista with 2GB is really on the limits with all the junk I put on my OS... and I can get some good Crucial sticks on special for 25$ a pop and go 64bit instead heh.
But I did try the diagnostic CD after you've mentionned it instead of using the "internal" one, and it gave me the same error on trying to load it "no enough user memory". Ah well.
Thanks!
You do not need the disc to run diagnostics on notebooks, the pre system asessment diagnostics are on the CMOS so they can be ran.
to run the hardware diagnostics, by turn the computer off, hold FN key down and power the system on. (you can release the FN key) this runs the pre system assesment test, if it completes with out errors it will ask you to run extended memory, this test can take long, but I would recommend running it.
if you get a fail code contact tech support, give them the code and it will be replaced.Best regards,
Azoth

XPSM1530_owner
315 Posts
345
0
Posted October 14th, 2008 11:00
Welcome to the Forum :smileyhappy:
Have you tried running the update again? There should be previous versions of the BIOS on the support site - try reflashing with one of these.
Another thing you could try - possibly reset your system is to shutdown, disconnect AC, remove battery, let sit for 10 min. Things may reset on reconnection and restart.
Might be worthwhile to boot from the Drivers & Utilities disk - run a diagnostic on the ram.
Good Luck