
UNSOLVED
Closed
Using two flat panel LCDs with a Latitude?
Hi,
Is there any way to use two flat panel LCD displays with a Dell Latitude D600 laptop? Can it be done with the port replicator or a full dock? I realize that one might have to be driven with analog SVGA output since there are no dual DVI output setups. My ideal solution would be to drive a 2001FP and a 2405FPW together.
If a D600 cannot drive two LCDs, can a D620 do it? What would it take to do that?
Right now I use a D600 with a port replicator to drive a 2001FP via DVI while using the laptop's own LCD as a second display. This works great. I tried today to use a second 2001FP hooked up via the port replicator's SVGA output (with the laptop display closed). This did not work. Strangely enough, the display hooked to SVGA worked fine but the original one hooked to DVI was all greenish and fuzzy and the monitor complained about not being able to display that mode. In the Display Properties both displays were set to 1600x1200, 32-bit color at 60Hz. My guess is that the display hardware in the laptop or the replicator just couldn't cope with a DVI and SVGA output at those resolutions.
Thanks for any tips.
Rob
Is there any way to use two flat panel LCD displays with a Dell Latitude D600 laptop? Can it be done with the port replicator or a full dock? I realize that one might have to be driven with analog SVGA output since there are no dual DVI output setups. My ideal solution would be to drive a 2001FP and a 2405FPW together.
If a D600 cannot drive two LCDs, can a D620 do it? What would it take to do that?
Right now I use a D600 with a port replicator to drive a 2001FP via DVI while using the laptop's own LCD as a second display. This works great. I tried today to use a second 2001FP hooked up via the port replicator's SVGA output (with the laptop display closed). This did not work. Strangely enough, the display hooked to SVGA worked fine but the original one hooked to DVI was all greenish and fuzzy and the monitor complained about not being able to display that mode. In the Display Properties both displays were set to 1600x1200, 32-bit color at 60Hz. My guess is that the display hardware in the laptop or the replicator just couldn't cope with a DVI and SVGA output at those resolutions.
Thanks for any tips.
Rob
Responses (1)
Solutions (0)

Charly277
9 Posts
204
0
Posted May 23rd, 2006 13:00