UNSOLVED

stek666

updated

20 years ago

Closed

S

stek666

7 Posts

0

29452

June 12th, 2006 08:00

Resolution on external Monitor (D620)

On my new D620 (with WGA+ intel) I'm unable to set the resolution of the external monitor higher as 1024x768.
 
On my "old" D600  was possible...
 
any ideas?
 
regards
Stefano

Message Edited by stek666 on 06-12-200611:52 AM

  • jgayman

    232 Posts

    185

    0

    Posted June 12th, 2006 12:00

    A couple questions as I don't understand  your statement "higher as 1024x768".
     
    What is the native numerical resolution of:
     
    1. Your new D620
    2. The monitor (and is it a CRT or LCD)
    3. Your old D600
     
     
  • jgayman

    232 Posts

    185

    0

    Posted June 12th, 2006 13:00

    Hmmm. I'm using a D600 as I type this with a Mobility Radeon 9000 video controller and I do not have 1400x1050 as an option.

    Most 17" LCD monitors have a maximum resolution of 1280x1024.

    I suspect it is an issue with the video driver currently loaded. I've been reading various messages concerning video issues with the D620.

    Do you know what the native resolution is of your 17" LCD?  I know you can set it to lower but typically not higher than the native resolution.

     

  • stek666

    7 Posts

    185

    0

    Posted June 12th, 2006 13:00

    on my old d600 I was connecting a 17" LCD monitor (from DELL) and I was able to set the resolution 1400x1050.
    on my new  d620 I connect the same LCD monitor and I can use only 10024x768, witch is to low for my expectation.
     
    Stefano
  • Windian

    71 Posts

    185

    0

    Posted June 15th, 2006 12:00

    The D600s with higher res (SXGA+) displays have a native resolution of 1400x1050.

    On your D600, when you connected the external monitor, it could have adjusted to the native resolution of your 17" LCD, which is very likely 1280x1024, and hard to tell from 1400x1050 at a glance.

    On your new D620, make sure that you have toggled the display to only use the external monitor and not the laptop LCD.  I think (hope) you should then get 1280x1024, or have it as an option. 

    Otherwise check that the monitor is recognized for whatever model it is - perhaps a driver is needed, or look at the "Advanced" display settings. There may be some settings about scaling image to panel size that need to be changed.

    Good luck.

  • stek666

    7 Posts

    185

    0

    Posted June 16th, 2006 05:00

    No,

    I try all, I call the dell support. At now is not possible to set a beter resolution !

    The support tell me to wait for new drivers !

     

    wait wait wait....

    Stefano